Electronics Forum | Mon May 31 11:08:28 EDT 2010 | padawanlinuxero
Hello I am having problems with the hydra camera, I start getting an error message saying that the camera couldnt look at the fiducials on the hydra, I went to the camera in service and turn it on to see the problem but I found out that the real pr
Electronics Forum | Wed Feb 19 09:52:45 EST 2014 | brendansales
Dear Rob, Got to the maintenance menu, under the Motor section, I selected Z motor and tried to initiate motor, there was no movement on the machine and I had the error message as below: F-MOT-MSETDYN Z/12: Position counter dead I suspect that ser
Electronics Forum | Thu Feb 13 00:43:06 EST 2014 | brendansales
Centering motor about to fail or has failed. > Centering motor about to fail or has failed. Hey Rdubya, Thanks for your help! Apparently that was not the problem. The Midas head had to be all the way down below the lower locking solenoid. After
Electronics Forum | Wed Jun 24 16:10:09 EDT 2020 | landrysmt
Hello, Finaly, What was the problem on your Hydra head? Maybe my message comes too late, but my answer might help ... It could be linked to a problem with the Hydra Z motor / encoder. In certain circumstances, the Hydra Z axis is not in the correct
Electronics Forum | Mon Oct 12 01:20:42 EDT 2020 | azdback
LandrySMT, after monitoring the errors and considering what we replaced, I also decided to replace the Z hydra motor and encoder. That fixed our problem. I looked at your message and I agreed that the next step was to replace this part. We ran hi
Electronics Forum | Mon Feb 17 18:53:34 EST 2020 | richgreen01
Hi all I am experiencing z force sensor errors on a couple of different nozzles ( not hydra ) any help appreciated.
Electronics Forum | Sat Jan 29 04:59:02 EST 2005 | Grant
Hi, MYDATA's are ok for lower volume, and they are very flexible. If you only have 1 or 2 trays of components and are on a tight budget, then you can even place the trays on the Y wagon behind the PCB so you can get away without the tray wagon. Al
Electronics Forum | Tue Feb 11 00:21:54 EST 2014 | bren
I suddenly encountered this error F-AXIS-C/9 Error says Axis has unstable zero point. Any advise?
Electronics Forum | Tue Feb 11 14:42:49 EST 2014 | rdubya
Centering motor about to fail or has failed.
Electronics Forum | Tue Feb 18 21:16:49 EST 2014 | brendansales
Thank you Sir, I'll go check it out.
winsouce.jpg)