Electronics Forum | Sat Jan 29 04:59:02 EST 2005 | Grant
Hi, MYDATA's are ok for lower volume, and they are very flexible. If you only have 1 or 2 trays of components and are on a tight budget, then you can even place the trays on the Y wagon behind the PCB so you can get away without the tray wagon. Al
Electronics Forum | Wed Mar 05 11:45:04 EST 2003 | msivigny
Hello Yngwie, When we look at the technical benefits of using N2, you'll find that your customer is trying to get a better product. Now as we discuss just a few of the reasons to use N2, when O2 is present in the heating atmosphere it carries oxides
Electronics Forum | Fri Mar 07 12:27:04 EST 2003 | msivigny
Hello Doug, thank you for the additional commentary, it has reminded me of another reflow recommendation that I'd like to make in general for readers. It's not specific to O2/N2 in ovens but in the method for creating and managing profiles for numero
Electronics Forum | Thu Mar 28 16:11:12 EDT 2024 | kingkelvin
In calibration menu - I see coarse measurement of z unit offset, z-unit offset, measure hydra camera z level, coarse adjust hydra tool offsets, and measure hydra tool lengths 1 - 8 - would it be any of these that I should run?
Electronics Forum | Mon Jul 16 13:54:53 EDT 2012 | markhoch
It's been a while since my MYDATA days, but let's give this a shot. Did you try putting the tool away and picking it back up? Make sure your Midas Head is cleaned and the tool is lubricated properly, then do a Center Base Leveling Calibration. (I t
Electronics Forum | Mon Aug 16 09:17:13 EDT 2004 | russ
For flatness - Put the part on a leveling plate and roll a dial indicator across it. The leveling plate is not required for a true flatness check but using this will also work for parallelism of lead base to top of body.
Electronics Forum | Thu Sep 09 00:57:42 EDT 1999 | Stoney Tsai
Currently, I have been requested to measure our SMT productity, capacity levels. I employed "pcs/day" as a base to come out with indicators for the top management decision-making. Anyone has other ideas to measure these two items? What are the lat
Electronics Forum | Thu Sep 09 08:58:07 EDT 1999 | Dave F
| Currently, I have been requested to measure our SMT productity, capacity levels. I employed "pcs/day" as a base to come out with | indicators for the top management decision-making. Anyone has | other ideas to measure these two items? | | What
Electronics Forum | Tue Oct 25 15:03:48 EDT 2011 | sjs2303
Hi Bert, For your second issue, are the tools well lubricated? If not the Midas head can fail to grab the tool and can generate the z motor error. Doing this followed by a base-centre level measurement should resolve your problem. Steve
Electronics Forum | Mon Jul 16 16:28:18 EDT 2012 | mikesewell
I'm somewhat frazzled by this one, not being too familiar with the MYs. Head is clean, tried different tools, same tool# from another MY, and have run the Centering Base Level Calibration to no avail. The component heights are correct and the par
