Electronics Forum: nad (Page 1 of 1)

Quad Machines? Good Points / Bad Points

Electronics Forum | Thu May 22 11:25:35 EDT 2003 | nad

Hi Jon, I recently had the opportunity to look over a used IIIc converted to a IVc. The documentation, software and spare parts supplied with the machine seem more than adequate, however, upon spending several hours cleaning, oiling, familiarizing,

Nitrogen chillers on Chinese waves

Electronics Forum | Thu Jul 13 16:11:51 EDT 2006 | johnw

No Disadvantages The reason they are used is they cool the boards at 2deg/p/sec leadfree spec for N2.Remmember the chinese have been building LF for years and are more advanced that Europpe nad America and most of the equipment is backed by Japanese

TOPAZ and EMERALD Manual

Electronics Forum | Sat Sep 05 08:14:50 EDT 2009 | propox

Hi Everybody, For this time I was using Philips CSM84V and VZ, now I bay Topaz and Emerald, nad I have ask for everyone, do anybody have manuals for this. Thanks for all help

SMT COMPONENTS

Electronics Forum | Mon Jul 15 15:09:52 EDT 2002 | larryk

I have found that it all depends on your leadtime. I've found that tube and tray are easier to get then taper nad reel. I figure it has to do more with the vender. It's much easier to sell small quantites (ie tubes) then to try and sell a huge reel o

SOT23 jumping off pads when reflowing

Electronics Forum | Tue Sep 16 23:58:03 EDT 2003 | iman

interesting! I recently invested a small personal fortune into books nad other related literature to boost my understanding the scientific properties of materials used in electronics and interconnection packages. One area( one of many areas) of p

Zevatech Z Axis fault

Electronics Forum | Wed Jul 01 13:41:25 EDT 2009 | jlawson

Are you sure it is the Z axis, and not the > rotation, I had one machine which often did > something similar, it would buzz loudly, > especially if you touched or applied rotation > pressure to the gear belt which rotates the > head. It never ca

CSM Philips v60 - problem with vision

Electronics Forum | Thu Jul 25 00:42:02 EDT 2013 | felo188

Hello everyone! I have problem with using vision in csm v60. Below describe: 1. Machine's third head takes one IC from tray 2. Goes to vision and take picture and moves IC 3. Goes to pick and place 4. When nozzle wants to place IC on board the

  1  

nad searches for Companies, Equipment, Machines, Suppliers & Information