Electronics Forum: non wetting (Page 1 of 30)

Component non wetting

Electronics Forum | Wed Apr 21 21:50:28 EDT 2004 | adam

Hi I recently having problems on the components having non wetting on the flex circuits. The profile that I am using is according to the solder paste suppiler recommended. Can anyone pls. advise? Regards

BGA non wetting

Electronics Forum | Wed Sep 15 20:59:23 EDT 2010 | genesan

hi All, Here i snap shot previous PCB(HASL) and current PCB(Immersion Silver).Base on the photo it could be PCB oxidize cause the non wetting?

BGA non wetting

Electronics Forum | Tue Sep 14 00:22:08 EDT 2010 | sachu_70

Hi Gani, non-wettting issues can surely be resolved. At first, would appreciate if the following info could be shared. Do you supply just one PCBA product to this client or is the complaint towards one of the many products that you deliver? Also, doe

BGA non wetting

Electronics Forum | Tue Sep 14 13:37:51 EDT 2010 | dan_ems

Hi Gany, did you check the temperature at reflow profile on this BGA ?

BGA non wetting

Electronics Forum | Wed Sep 15 01:16:36 EDT 2010 | dan_ems

Hello, what type of solder paste use, and this component is made for lead process?

BGA non wetting

Electronics Forum | Wed Sep 15 03:04:13 EDT 2010 | genesan

kester 562 clean process and this leaded part.

Component non wetting

Electronics Forum | Thu Apr 22 04:55:42 EDT 2004 | Richard

Have you tried using Concoat MUST II solderability tester to test on the component terminal are of good solderability. Non-wetting may occur due to oxidation or contamination on component terminal. So for immediate response to you problems is to used

Component non wetting

Electronics Forum | Mon Apr 26 17:12:14 EDT 2004 | babe

Take a solder iron with some wire solder and attempt to tin the leads of the component. Look under magnifier or microscope. Did they wet? If not try fluxing them with liquid flux and then soldering again. Did they wet? If they did not then you may wa

Component non wetting

Electronics Forum | Thu Apr 22 21:34:58 EDT 2004 | adam

Thanks guys. I am from a subcon, we can't change the solder paste supplier and there is only one approved vendor for this component. I think I will try on the component solderability. Regards

BGA non wetting

Electronics Forum | Tue Sep 14 02:12:22 EDT 2010 | genesan

Hi Sir, Thanks for reply and base on our system the same part are using for 2 model only and the problem occur on both assembly.By the way as feedback it happen on random pin of this BGA only.

  1 2 3 4 5 6 7 8 9 10 Next

non wetting searches for Companies, Equipment, Machines, Suppliers & Information