Electronics Forum: nozlles (Page 1 of 1)

Magnetized HSP Nozzles

Electronics Forum | Fri Jan 23 13:17:59 EST 2004 | Gabriele

Make sure chips (some Resistor contain nickel,or A-42 (Fe-Ni)leads made like SOT-23, etc )some time they also are magnetized and get attracted by nozlles tips. rgds

Selective Soldering - nozlle material

Electronics Forum | Thu Jan 24 09:47:38 EST 2019 | my3sons

We use 4140 steel (same as a lot of other OEM's). The user will need to pre-flux and tin before installing in the machine.

Selective Soldering - nozlle material

Electronics Forum | Sat Jan 12 11:47:25 EST 2019 | ranap121212

I am looking for a good material for selective nozzle. We are currently using Kovar but it is expensive and wears out it has very good wetting properties.I looking for a material or coating that would allow me to keep the binder flow and with less co

SMT Component placed upside down

Electronics Forum | Wed Aug 03 10:01:39 EDT 2005 | GS

Hi Crishan, sorry, "pbm" is a short way to say problem. In the past ('89), we had same magnetic pbm also with metal nozlles on Dynaper MPS-2500. Some time, we found also chips received from supllier already magnetized. Solution was to put the r

vitronics delta wave malfunction errors :pcb expected at exit

Electronics Forum | Fri Sep 14 03:43:16 EDT 2012 | mili

Hello!I have a delta wave with these problems:offtime of lambda wave tracking is too long and when modify offtime setting to a negative value for a fast stop on tracking position of lambda wave, the wave pass on stand-by with a delay of half of leg

error message :pcb expected at exit

Electronics Forum | Fri Sep 14 04:11:16 EDT 2012 | mili

Hello!I have a delta wave with these problems:offtime of lambda wave tracking is too long and when modify offtime setting to a negative value for a fast stop on tracking position of lambda wave, the wave pass on stand-by with a delay of half of leght

  1  

nozlles searches for Companies, Equipment, Machines, Suppliers & Information