Electronics Forum | Fri May 26 16:24:45 EDT 2006 | Jak
Due to spacing issue, we are considering using power bricks with tin/lead solder ball instead of PTH package. The solder ball is 40 mil diameter. Our CM suggested they do hand place since the pick and place nozzle cannot pick up and hold the part due
Electronics Forum | Thu Jun 22 11:39:09 EDT 2006 | russ
So Ev, why did you just respond to a question that you admitted not knowing about? is this not the same? ie... nozzle set error, you know this could be a software conflict error as well? You answered as if it was an inspection error, when I did no
Electronics Forum | Fri Jul 07 06:55:02 EDT 2006 | Rob
I HATE them. I have tried most types and am not impressed. By the time you add on all of the extras such as tape feeders, trays, nozzles, guidance, etc. you could nearly buy a used Mydata/Contact/Quadra/Versatronics/Quad/Daum which would give you p
Electronics Forum | Fri Nov 10 09:21:20 EST 2006 | Steve
I had a PDR Lightmaster Pro at the last place I worked at, and I thought it was the best rework station I've ever used. Not only because of the fact that no nozzles were needed, but the heat delivery from the focused IR light was superb. I don't know
Electronics Forum | Mon Aug 28 09:20:42 EDT 2006 | pr
Yeah, changing it while you run is ridiculous. I would take my thinnest part and play with the thickness, until you make it as thick as you can (and still place the part with good results). Then use that thickness for all. You can put a dial indicato
Electronics Forum | Fri Aug 25 23:54:26 EDT 2006 | mika
If You adjust the focus to perfection, You still need the UIC GSM calibration kit, so that the machine will know where the spindles are according to the cameras (OTHC, P2P:s, fiducial camera), X-Y-Theta-spindles, nozzle changer, feederbanks and mach
Electronics Forum | Fri Sep 22 15:35:14 EDT 2006 | lheiss
Hello all, Finally ready to run my first 14 up array and the machine picks up the part moves to the placement location, them moves to home and drops the part. The Z axis never moves. I do get a "run error 1" at about the 4th placement (if it was a
Electronics Forum | Thu Oct 05 23:44:55 EDT 2006 | zoltans
Hi, Has anyone got first hand experience with the JT wave soldering machines, WS series? I use a low solid VOC free flux and it seems I have problems atomizing the flux properly and this generates soldering defects, leaving lumps and big solder bal
Electronics Forum | Sun Oct 08 23:37:37 EDT 2006 | zoltans
Hi, Has anyone got first hand experience with the JT wave soldering machines, WS series? I use a low solid VOC free flux and it seems I have problems atomizing the flux properly and this generates soldering defects, leaving lumps and big solder bal
Electronics Forum | Mon Nov 06 10:03:19 EST 2006 | SWAG
I don't know of any articles but you will see the following problems: The flux will evaporate from the paste and your solder joint will look very grainy or will not reflow at all. The paste will not have a good, tacky quality. Your pick and place
COT specializes in high quality SMT nozzles and consumables for pick and place machines. We provide special engineering design service of custom nozzles for those unique and odd components.
2481 Hilton Drive
Gainesville, GA USA
Phone: (770) 538-0411
