Electronics Forum | Tue May 30 11:51:43 EDT 2000 | JAX
Sal, I have seen this problem placing SMT connectors which exceed 60mm in length. Although I did not use siemens equipment at the time I am not sure if they will place enought force to seat the entire connector flush to the board. They have a maximun
Electronics Forum | Mon Sep 13 21:18:29 EDT 1999 | Dave F
| Hi, | | Recently encountered missing components problem at the SMT process. | Among 13 chip components from the same part number mounted on the board, only 4 ( located in a same row and next to each other) were missing after post reflow. Checked t
Electronics Forum | Tue Mar 16 14:05:04 EST 1999 | Steve Skinner
| Does anyone have any recommendations on spray fluxers? Are there major differences between the high priced ultrasonic machines to the low priced flux/air spraying machines? We are going to be spraying an OA flux with 11% solids content. Are there a
Electronics Forum | Mon Nov 09 11:56:59 EST 1998 | Stefan W.
At least I can imagine what happens and it may solve your problem. If the vacuum is already turned on above the component there will be an airstream above and around the component. This might even suck the air out of the cavity, which supports the co
Electronics Forum | Wed Aug 28 18:08:07 EDT 2002 | MikeF
This looks like it may be a good application for an Air-Vac or Wenesco type solder station. It is a solder pot that has a small motor to pump solder up through a chimney. You can put different nozzles on the top of the chimney, so you only apply sold
Electronics Forum | Thu Sep 05 17:50:43 EDT 2002 | pjc
There are no "standard" spray fluxers that come w/ the Electra. The spray fluxers offered are: SelectaSpray? -Fixed multiple nozzles spray fluxer, 510 mm (20 in. ) Max width AccuSpray?- Reciprocating spray fluxer, 600 mm ( 24 in.) ext. only) Opti-Flu
Electronics Forum | Tue Jan 28 18:38:36 EST 2003 | joeherz
Mike, I've tried the high side of the flux preheat spec with no success. I did just get off the phone with Electrovert tech support...... Get ready. This machine is configured with a Contour Plus N2 nozzle. We are not running N2. According to M
Electronics Forum | Thu Mar 20 13:22:27 EST 2003 | bmaheu
James, I've done some extensive studies cleaning BGA's while I was employeed by one the companies you are considering. In an attempt to avoid being commercial I will use general statments to address your question(s). The key to cleaning underneath
Electronics Forum | Wed Jun 23 10:26:53 EDT 2004 | exmaintenanceleader
Grant and all! CP-2 is the oldest fuji as I have been operated. CP-3 is built in 1989 as a new mc. Now 15 mc I now they runs in 3 shift widouth problems when they need countinous runing comes the problems. conroll card and relay contact problems at
Electronics Forum | Tue Jun 15 15:57:00 EDT 2004 | russ
I have used one in the past and wish I had one now. Is that enough input? We had great success with this machine. The large lower preheat and board supports worked very well for large thin boards. We never experienced any problems with this machi
COT specializes in high quality SMT nozzles and consumables for pick and place machines. We provide special engineering design service of custom nozzles for those unique and odd components.
2481 Hilton Drive
Gainesville, GA USA
Phone: (770) 538-0411