Electronics Forum | Wed May 26 10:00:03 EDT 1999 | David Scott
| | | | | | | | | | | | Any suggestions on how to maintain Adhesive dispensing nozzles??? They seem to plug up over night and it is starting to get on my nerves. We have tried leaving the nozzles in the machine, removing them and soaking in alcoh
Electronics Forum | Tue Mar 16 14:23:44 EST 1999 | Steve Skinner
| Does anyone have any recommendations on spray fluxers? Are there major differences between the high priced ultrasonic machines to the low priced flux/air spraying machines? We are going to be spraying an OA flux with 11% solids content. Are there a
Electronics Forum | Mon Mar 29 16:56:58 EST 1999 | Chrys Shea
| | Does anyone have any recommendations on spray fluxers? Are there major differences between the high priced ultrasonic machines to the low priced flux/air spraying machines? We are going to be spraying an OA flux with 11% solids content. Are there
Electronics Forum | Fri May 04 02:32:10 EDT 2007 | jmelson
Thanks! Well, the procedure in the book says to first calibrate the mech aligner with the beam sensor, but that exceeds the X travel. I guess you can just eyeball it off the nozzles and then use trial and error. While poking around on the machine
Electronics Forum | Thu Dec 06 12:37:14 EST 2012 | deanm
We are having difficulty with bridging on a 2x50 pin 0.050" fine pitch connector using our selective soldering machine. It usually bridges at the end of the row, but sometimes it bridges all the pins together as it drags across (solid bridging). I
Electronics Forum | Mon Nov 10 23:20:55 EST 2008 | stanyserrao
Light Units are replaced with new if the problem > of lights then it will not vision process the > nozzle center measrement and resolution Jigs > too.. > > Jig is meauring in trace mode and > identifiying all leads which are fine > fitch. > >
Electronics Forum | Fri Sep 20 20:03:55 EDT 2002 | mjabure
Well chip I ought to leave you guys hanging in the breeze on this one , but here goes. Steve, your assumption that the nozzle is calculated as part of the component body for types 11 & 12 is incorrect. during center test on the 643's one of the par
Electronics Forum | Wed Jun 11 16:30:33 EDT 2003 | T.Vick
You have received some great feedback so far. I would like to summarize and add a few points regarding maintenance. You should start (as recommended already) by verifying your component library data. Using the default values from the master library i
Electronics Forum | Tue Mar 20 00:02:00 EDT 2007 | Darby
Some causes of skewing. If you have exhausted all mechanical problems for that head. Pickup data from tray is incorrect. If you aren't picking up in the exact centre it is possible that the component is being skewed after vision adjustment i.e. cent
Electronics Forum | Mon May 07 15:03:06 EDT 2007 | jmelson
Yes, I took the chuck off head 3, and made my own nozzle, which is working quite well. I can't set head 3 to vision, as this machine doesn't have the vision system. I set it to "IC" and that seems to work fine. I set mech alignment 1 and 2 to yes,
COT specializes in high quality SMT nozzles and consumables for pick and place machines. We provide special engineering design service of custom nozzles for those unique and odd components.
2481 Hilton Drive
Gainesville, GA USA
Phone: (770) 538-0411