Electronics Forum | Mon Oct 04 15:10:42 EDT 2010 | 18424
Hi Michelle, Due to the dense population of through hole on some boards, after a 35 minute wash, some connectors or battery holders remain wet. Currently we put them into drying ovens at 70c for a Minimum of a half hour. We do occasionally air dry un
Electronics Forum | Thu Jul 07 14:58:18 EDT 2011 | vickt
Prasad, It is typical when experimenting with new materials to have to adjust the airpressure on the syringe and the stroke of the PDP piston (screw adjust on top of the PDP pump). You can add mutiple cycles in the comp Db to make larger dots with th
Electronics Forum | Tue Jan 17 11:10:51 EST 2012 | leemeyer
1. The flat black connectors that you are refering to are for the nozzle changers. 2. The nozzle changers can be mounted anywhere on the feeder base and their position must be taught using the handheld programmer. 3. If you have no power to the feede
Electronics Forum | Tue Feb 07 05:41:20 EST 2012 | ngineer
I've got an issue, i can't seem to figure out. I think I need to apply a global offset to all my placements for some reason, and I would like to know why, before I do it. nozzles work, picks seem ok, but the placements are off by about 1/2 the widt
Electronics Forum | Mon Feb 04 11:01:44 EST 2013 | bobpan
The way its supposed to work...is....when you do a function 30 the z axis should step down until the nozzle tip is seen in the quad align or laser align. The readout should have a nozzle height but if its the earlier firmware for the machine it might
Electronics Forum | Thu Mar 14 07:22:22 EDT 2013 | fredcalkins
This problem has become a real issue with the tacky silicon used in many LEDs. Cree has recomended that the pull off angle be changed for the cover film as mentioned by the previous commentor. With these new silicon LEDs they are recomending teflon o
Electronics Forum | Mon Apr 08 16:41:07 EDT 2013 | rgduval
I need to replace the number 1 head on my CSM84. The nozzle is stuck in the tube, and I haven't been able to get it out. I have, however, done a number on the nozzle while trying :) I have a new head to put in there, but, am being stymied by the r
Electronics Forum | Wed May 01 11:31:38 EDT 2013 | jaimebc
Stephen, Bill, Thaks for your input. We are currently waiting for nozzles since the ones we have are badly oxidized. We do have a deoxidizing gel that we got from ERSA, not sure if it contains Adipic Acid, but it is what was suggested we used. Once
Electronics Forum | Fri Aug 22 02:10:55 EDT 2014 | mdang
I wonder if anyone can help me with this problem. My FUJI CP65 with 0201 camera is working fine for a while. Now, it starts losing the vision on 0201 camera. The system will run for a while then I don't see the part on the part monitor when the nozzl
Electronics Forum | Thu Nov 13 12:49:45 EST 2014 | dyoungquist
I have no experience running a "move the board" selective solder so can not compare the 2 methods..... We have been using an RPS Rhythm "move the pot/nozzle" system since 2008. We are using it solder thru hole components onto boards that often have
COT specializes in high quality SMT nozzles and consumables for pick and place machines. We provide special engineering design service of custom nozzles for those unique and odd components.
2481 Hilton Drive
Gainesville, GA USA
Phone: (770) 538-0411
