Electronics Forum: nozzles (Page 1 of 211)

SAMSUNG nozzles

Electronics Forum | Wed May 25 17:33:52 EDT 2005 | russ

What's going wrong with the nozzles that you have to replace? Are you running CP40 / 45 models? We have used our N08 nozzles for 5+yrs now without replacing. Russ

SAMSUNG nozzles

Electronics Forum | Wed May 25 18:40:49 EDT 2005 | jsloot

The ends of the nozzles look flattened. I haven't measured the total length yet to see if it is in tolerance or not. That is for tomorrows "to do" list as well as calling tech support. When I slow the machine speed down and watch what is happening I

SAMSUNG nozzles

Electronics Forum | Wed May 25 13:02:57 EDT 2005 | jsloot

I have two Samsung machines running about 500 hours a month each. Placement rate is on the average 12,000 CPH between the two. The life expectancy of the nozzles used on 1206 packages seems rather short to me. It was about 2 months ago I replaced the

SAMSUNG nozzles

Electronics Forum | Wed May 25 18:27:06 EDT 2005 | russ

So what is happening to these nozzles? Are they sliding off of the compliance assy?, getting dinged? Have you contacted dynatech SMT about this yet?

SAMSUNG nozzles

Electronics Forum | Wed May 25 19:11:49 EDT 2005 | jsloot

That I can do, checking the placement height that is and the clamps. I believe my clamps are 4mm. If your nozzles have survived 5 years how many placements is that...roughly? In the billions?

SAMSUNG nozzles

Electronics Forum | Tue Jun 07 12:34:24 EDT 2005 | bradlanger

We have a CP-40 and a CP-50 and have placed millions of 1206 parts in the last year and there is minimal wear on the N08 nozzles.

Rework nozzles

Electronics Forum | Mon Dec 17 16:22:23 EST 2007 | dborgelt

I need to have a rework nozzle made up to remove some connectors. Does anyone know of a good company that does this?

Rework nozzles

Electronics Forum | Mon Dec 17 16:34:51 EST 2007 | dborgelt

I need to have a custom rework nozzle made up to remove some connectors. Does anyone know of a good company that does this?

SAMSUNG nozzles

Electronics Forum | Wed May 25 17:42:44 EDT 2005 | jsloot

They are a CP40 and CP50. The CP40 is fairly new and the 50 is fairly new but we bought it as a used piece. It is in good condition. As far as I can say everything seems set up correctly. By the sounds of your reply I should dig into this more deeply

Rework nozzles

Electronics Forum | Mon Dec 17 21:59:39 EST 2007 | davef

We've talked about doing this several times previously here on SMTnet. Search the fine Archives. One of our favorites is: http://www.smtnet.com/forums/Index.cfm?CFApp=1&Message_ID=10155

  1 2 3 4 5 6 7 8 9 10 Next

nozzles searches for Companies, Equipment, Machines, Suppliers & Information