Electronics Forum | Thu Jan 14 04:45:16 EST 2016 | saimen
Hi There , Glad to contact with you , Here is Saimen in Tianweisheng , wish we will have a good cooperation in the furture if we have the honor . Our company is one of the largest custom-made PCB manufacturer in China. We can OEM,ODM,EMS single side
Electronics Forum | Fri May 22 12:42:43 EDT 2015 | deanm
Sr. Tech, you are right in that there is no verification of the profile. We are a Class 3 high mix OEM. We have visual inspection after SMT. We have not seen problems with wetting, grainy solder, cold solder, charred boards, etc. that would indicate
Electronics Forum | Fri Jun 12 05:12:46 EDT 2015 | xavierchew
We are a Singapore based independent distributor of electronics components with over 7 million parts available from more than 1000 quality suppliers (OEM, CEM & Franchised Disti). We can help to source for hard to find and allocated components. We ha
Electronics Forum | Thu Jan 14 04:41:29 EST 2016 | saimen
Hi There , Glad to contact with you , Here is Saimen in Tianweisheng , wish we will have a good cooperation in the furture if we have the honor . Our company is one of the largest custom-made PCB manufacturer in China. We can OEM,ODM,EMS single side
Electronics Forum | Mon Aug 20 16:45:27 EDT 2018 | dleeper
Ideally you would want factory training but with old equipment that might not be feasible. the manufacturer might not offer training for legacy products, or the cost of the training is out of budget. Your next best bet is to find a third party suppl
Electronics Forum | Tue Apr 23 06:26:18 EDT 2019 | jfeustel
Kanetic did implement a feature into their PLC code that would allow for simple reversal of the board flow. This is why the conveyor suddenly reversed direction after so many years. Because the feature was invoked by holding down a button it was kno
Electronics Forum | Tue May 28 18:31:08 EDT 2019 | jlawson
Solder paste flux is main contributor, Lead termination chemical-oxide by products and PCB Plating-Chemicals. Reflow profile would have very limited if not no impact really unless is way off. Paste volume control and Stencil design plays a big part
Electronics Forum | Fri Aug 02 12:57:38 EDT 2019 | aaronhodge
Hello All, I am a few months in with a new employer, spending much of my time with AS9102B First Article Inspections. This company is a Micro-Chip and PCA OEM but also designs, develops and manufactures products for a handful of customers, as well.
Electronics Forum | Sat Nov 09 19:18:08 EST 2019 | kylehunter
Hi, I just set one of these up a month or so > ago, so it's all pretty fresh. The 265s have a > pressure sensor amplifier box that needs > calibration using the OEM calibration jig. OR you > can use a 3 quid digital luggage scale from Ebay. >
Electronics Forum | Fri Feb 21 10:59:15 EST 2020 | slthomas
I used to work for an OEM that made professional audio equipment (studio monitors, mixing boards, etc.). The mixers required precise alignment of LEDs, switches, and pots in the sheet metal so we used aluminum alignment fixtures during wave solder. T