Electronics Forum | Fri Jun 13 15:13:49 EDT 2003 | larryk
Well, I really never understood why. It was a custom part for that model/make and they would of been the sole supplier. All I wanted was the new part number so I could purchase it. I know that the above posts are saying automoblies are not the same
Electronics Forum | Wed Jul 23 08:21:55 EDT 2003 | James
Here we go again. I tried changing paste and that did nothing. Literally solder balled up and flew to the next pad. What would be a short term fix to use up all baards with white tin. Is there a fix if the board house did not manufacturer the boards
Electronics Forum | Wed Jul 30 09:35:39 EDT 2003 | jseagle
What do you all think about Cookson trying to sell off their Speedline division? I was just about to purchase an Electrovert Aquastorm 100 but now I am not so sure. Does anyone here have an Austin American in-line wash? Looking for feedback as the
Electronics Forum | Tue Aug 05 10:01:42 EDT 2003 | Sat
You are welcome and thank you for all the inputs. You are right in that these new machines have the camera vision. Like I said in my other post, my engg's like all the machines but prefer Universal and Mydata for a bit more available flexibility like
Electronics Forum | Thu Aug 14 15:46:35 EDT 2003 | dphilbrick
Although DaveF's answer was probably more applicable and there is some really good info on Tin Whiskers it doesn�t really answer the question either from what I saw. I suspect this will become a much larger issue as we all are weaned off of lead!
Electronics Forum | Thu Sep 04 16:44:19 EDT 2003 | mleber
We are a military contractor running mixed technology CCA's. We currently "map" all defects off reflow and wave by indicating the defect on a map (plot from gerber) then passing it on to rework. The map is used for SPC data as well as overall perform
Electronics Forum | Tue Sep 23 18:48:57 EDT 2003 | ericsbrown
We have an application where we are applying a heatsink with a thermal tape that has pressure sensitive adhesive (psa) on either side. Does anyone know of an off-the-shelf heatsink press that we could use to apply a consistent, measured force for a
Electronics Forum | Thu Sep 25 10:27:45 EDT 2003 | davef
Datum: Many times the requirement for a heat sink is anticipated poorly by the designer. So, adding a clip becomes burdensome and too expensive for a respin. Other times, there is no off the shelf clip for the component, as you say. So, a well des
Electronics Forum | Mon Oct 06 18:24:34 EDT 2003 | pjc
what type of belt is it and what material is it? round belt, flat belt, etc... if its from a PCB transport conveyor or other PCB handling system, I recommend you contact the OEM. I have spliced belts before- rubber round belt off old Fuji loader and
Electronics Forum | Wed Oct 29 17:52:41 EST 2003 | adlsmt
What kind of equipment do you have now to do the 1 off boards? Is there enough profit margin to process the 200 the same way? If not, there is not enough to justify new equipment and to outsource 200 pcs with 100% traceability requirements would
