Electronics Forum | Thu Apr 01 05:19:04 EDT 2021 | micropak
Thanks for the tip. I have the old belt and since it is too damaged (Steel wires showing up here and there)that measuring the length is probably not possible. I can however measure width and tooth pitch. I will give it a try. I have also requested A
Electronics Forum | Wed Apr 28 17:45:14 EDT 2021 | mishafockin
This is a very tricky question butt... we should be able to afford up to 200k for a full line (printer/PnP/inspection/oven) I know the cost of feeders will be very critical but looks like the good old pneumatic not cutting it anymore.
Electronics Forum | Thu Apr 29 03:34:47 EDT 2021 | ttheis
That is a very tight budget for a new line with the capabilities you describe. You might be better off with a refurbished line from a reputable dealer. Equipment that is only a few years old can get you the capabilities you want within your budget.
Electronics Forum | Wed May 26 06:07:07 EDT 2021 | bukas
its not that you should never open it manually, it just can be a problem sometimes. CP45 have a few problems with data corruption and this can be one of them. just make sure you regularly backup disk, and dont delete old backups straight away.
Electronics Forum | Tue Sep 21 20:49:56 EDT 2021 | kghadiya
Hello Folks, I have some questions regarding penalizing board in CircuitCam. I am using kinda old version of CircuitCam but if someone know this software, it will easy for them to figure out. Does anyone know CircuitCam who can help me out? Please
Electronics Forum | Fri Oct 08 20:20:37 EDT 2021 | glenenglish
Thanks ProcEng1 for the input New, the factory does super deals on feeders as a package. But since I'll only run the machine machine 500 hours per year, we can get a pretty clean used machine 1-3 years old for about 50% of the new money. The lightin
Electronics Forum | Thu Oct 14 18:23:40 EDT 2021 | mikeybinec
OK, thanks for access a few decades ago when I was a kid, I printed soldermask and legend inks on circuit boards. Printing solder mask, (PC-401, SR1000, LPI) I would use SM-1000 stencil material on 86 or 110 mesh I've been trying to find sm-1000 bu
Electronics Forum | Wed Feb 02 20:14:56 EST 2022 | dwl
Make sure your pick up and Placement theta are correct. SOT-23 are notorious for having bad theta data in part libraries. I had an old placement machine that would center the part with an upward camera, looking at the feet. If I had the wrong pick t
Electronics Forum | Thu Feb 10 20:32:03 EST 2022 | Claude_Couture
That was my first tool I made for that purpose, a mini guillotine with marks showing quantities of 7, 11, etc, that they needed. Pull tape to mark, cut, repeat... After tens of thousands, it gets old. Also repetitive injuries became a factor.
Electronics Forum | Fri Feb 11 20:16:43 EST 2022 | mihai_voivod
Hi guys, This stubborn conveyor (inline smt 1m 2 stage) keeps popping off its track. I have tried to replace the old belt, turn the new belt around, tighten it as much as I can, but it keeps coming off the little wheels as shown in the picture. D