Electronics Forum: omni and blowr (Page 1 of 1)

Printer and Reflow Oven Recommendations

Electronics Forum | Thu May 14 10:00:14 EDT 2015 | swag

I like MpM personally - run forever and programming is easy and leads you through it. It's hard to miss a step of programming with MpM software. DEK's a little harder (for me) but still very nice controls. The pluses of DEK - DEK has a high freque

PTH Hand Soldering and Rework Training

Electronics Forum | Tue Jan 14 20:32:41 EST 2003 | davef

There's just about 4 beezillion companies that give solder training. Some are: * BEST Rolling Meadows, IL 847-797-9250 Bill Westmoreland (bwestmoreland@solder.net) http://www.solder.net/ * Circuit Technology 340 Raleigh St Holly Springs, NC 27540 (

Can anyone tell me that between Mirtek & Kohyoung which AOI machine will be better and why?

Electronics Forum | Tue Feb 17 00:18:33 EST 2015 | shahrat

I am planning to bye MV7-omni. What do you think of this machine?

Can anyone tell me that between Mirtek & Kohyoung which AOI machine will be better and why?

Electronics Forum | Tue Feb 17 12:58:11 EST 2015 | anvil1021

The MV-7 OMNI is a Great Machine, has the same 3D Solution MV-9 Quad Moire Multi Frequency System. You will not be disappointed, you will find new ways to use the 3D system as time goes on and it is rock stable and incredibly precise. Either the MV-

Buying 1 or 2 Post reflow AOI and 1 Pre reflow AOI

Electronics Forum | Fri Nov 06 07:46:33 EST 2015 | clampron

Good Morning RedChilli, I have worked with Mirtec for quite a few years. I have looked at some of the other machines mentioned but have no practical experience with them. I started with the Mirtec MV-2 (long ago)due to the success of this platform,

  1  

omni and blowr searches for Companies, Equipment, Machines, Suppliers & Information