Electronics Forum | Wed Jan 20 18:57:06 EST 2021 | echanelo
Hello, I'm in desperate need of a boot up disk for my Electrovert Omniflo 5 oven. Type: OMNI 5SE Date: 5/98 I would like to purchase or borrow. Or maybe someone can point me the right direction it would be greatly appreciated. Thanks
Electronics Forum | Mon Mar 20 11:48:21 EST 2006 | Chunks
jdengler may be right. Had a 10 zone do the same thing. It was a couple links in the chain.
Electronics Forum | Sat Mar 25 15:27:21 EST 2006 | Mike ZIG
Hi all, What is the best oil to lubricate the chain ? Mike
Electronics Forum | Mon Mar 27 07:36:15 EST 2006 | Loco
Soltec prescribes Turmofluid 40b. Seems to work ok.
Electronics Forum | Wed Sep 25 11:12:48 EDT 2013 | derekj
Hello all. Running a new to us Omniflo 5 and realized that there is no ports for thermocouplers or wires to do any profiling. There is a space on a front panel for thermal profiling inputs, so I am assuming it was optional, just not spec'ed on this m
Electronics Forum | Mon Mar 20 09:28:47 EST 2006 | PWH
We just went through this exact same problem on an OmniFlo. We did all the stuff Marc talks about and the problem went away completely. As Marc states, clean the chain guides! You will will see lots of junk near the last zones(s).
Electronics Forum | Mon Mar 20 06:21:42 EST 2006 | AR
Have a problem with Omniflo 5 (-97 vintage) pin chain conveyor. Occasionally the conveyor stops for a second or two, then makes a slight jerk, then stops again, makes a jerk etc. Then suddenly the problem goes away only to return next day (we switch
Electronics Forum | Fri Feb 25 16:16:01 EST 2005 | pjc
Here are some 5 zones models to look for: Electrovert OmniFlo5 Conceptronic HVA70 BTU VIP70 Vitronics SMR or XPM 520 Heller 1088 (4 zone)
Electronics Forum | Thu Mar 23 07:55:10 EST 2006 | Peter
We had the problem for � a year, and cleaned everything. We replaced the DART-control unit, and have not seen the problem since
Electronics Forum | Thu Mar 23 23:21:10 EST 2006 | AR
100 cm/min) the motor runs without complaint. Too bad we run the conveyor as slowly as 10 cm/min... I'll try replacing the control board next when I get my hands on one.