Electronics Forum | Mon Jan 19 08:37:16 EST 2009 | lkpdsund
Hello all! We possess a speedline electrovert omniflo 7 reflow oven at my site. Last week we examined how the solder profile was affected by fan-speed and by providing the soldering process with compressed air(O2) or nitrogen(N2). We also ran the sa
Electronics Forum | Mon Sep 01 04:55:20 EDT 2008 | benefon
Hello all Our Omni 5 has given the 'Cooling module high temp' warning twice during the past month. I suspect that the blower motor is the culprit but have not been able to verify this because the oven has started up normally after acknowledging the
Electronics Forum | Tue Feb 01 10:25:24 EST 2005 | Scott Baker
Jay - I read your report and was interested to see that you ran your evaluation on a Heller 1500 5 zone. We have been hearing for some time that a larger machine (7 zone min)with higher temp heaters and fan motors would be required. Is yours a "hi t
Electronics Forum | Fri Apr 16 10:34:29 EDT 2004 | kauer
A couple of questions for You. How old is this oven? Does it have a history of problems? When I have seen speed variations with our Omniflow 7s it is usualy the encoder but it usually spikes rather hard in one spot. You can see this physically and by
Electronics Forum | Sat Dec 17 16:46:45 EST 2011 | eadthem
Startup current depends on your configuration. ours dose zones 1,2/ 3,4/ 5/ 6,7 last i checked it pulled about 40-55 ish on start up and 25-35 during run. our profile is a slow ramp till 170c then a fast ramp to 285c 280c(last 2 zones). 1707's
Electronics Forum | Tue Aug 11 18:44:22 EDT 1998 | Dave M
| Good day. We have just purchased a HOLLIS POLYCLEAN SMT Machine. We did not receive a manual and for installing the machine, we need the indications for the ventillation system: ie the number of CFM for the blower. | We would greatly appreciate i
Electronics Forum | Sat Oct 17 10:24:12 EDT 1998 | smd
| | | | | | | It seems like most people want to X-Ray their BGAs. We're going to start doing a lot more of them and need to consider X-ray, too. | | | | | | | Q: Do most people/companies X-ray everyBGA or do they just do SPC? | | | | | | | Q: Can yo
Electronics Forum | Mon Oct 19 14:24:06 EDT 1998 | Justin Medernach
| | | | | | | | It seems like most people want to X-Ray their BGAs. We're going to start doing a lot more of them and need to consider X-ray, too. | | | | | | | | Q: Do most people/companies X-ray everyBGA or do they just do SPC? | | | | | | | | Q:
| 1 |
