Electronics Forum: omniflo motor (Page 1 of 2)

Omniflo motor

Electronics Forum | Wed Mar 02 06:21:44 EST 2005 | pjc

Why don't you ask the mfr.'s tech support ? http://www.speedlinetech.com

Omniflo motor

Electronics Forum | Thu Mar 03 11:08:34 EST 2005 | Slow Ride

It's your brushes. Had the same thing happen not too long ago. Also, fill that gear box.

Omniflo motor

Electronics Forum | Wed Mar 02 04:32:07 EST 2005 | Hannu

Hi all We have an Omniflo 5 (-97 vintage) with pin chain conveyor. Lately the chain drive motor has started to emit some chirping noises, as if there were a bearing running dry or something. Is there some kind of maintenance schedule specified for t

Omniflo motor

Electronics Forum | Thu Mar 03 09:58:59 EST 2005 | Marc

The gears should be wet. This gear box acts like a rear end axle. Not sure of the lubricant but it is like a red transission lube, comes in as complete unit from supplier. You can't get the lube from Speedline since it is sold as a complete unit.

Omniflo 5 conveyor

Electronics Forum | Thu Mar 23 23:21:10 EST 2006 | AR

100 cm/min) the motor runs without complaint. Too bad we run the conveyor as slowly as 10 cm/min... I'll try replacing the control board next when I get my hands on one.

Omniflo 5 conveyor

Electronics Forum | Mon Mar 20 06:21:42 EST 2006 | AR

Have a problem with Omniflo 5 (-97 vintage) pin chain conveyor. Occasionally the conveyor stops for a second or two, then makes a slight jerk, then stops again, makes a jerk etc. Then suddenly the problem goes away only to return next day (we switch

Omniflo 10 oven

Electronics Forum | Thu Apr 15 23:13:29 EDT 2004 | pyro747

What we are finding that the volts on the Drive motor are dropping when the oven gets hotter. As for the encoder not pick up the drop in speed, I ran the wires for the encoder outside of the oven away from everything, didn't help!!! I swapped PC's

Omniflo 10 oven

Electronics Forum | Thu Apr 15 01:29:35 EDT 2004 | pyro747

Hello Everyone, I am having a pin chain speed problem. The speed of the chain will slow down after start up of the oven. Example if you set the conveyer to run at 41 in/min, as the oven warms up of conveyer will slow down phycally but won't chan

Omniflo 10 oven

Electronics Forum | Fri Apr 16 10:34:29 EDT 2004 | kauer

A couple of questions for You. How old is this oven? Does it have a history of problems? When I have seen speed variations with our Omniflow 7s it is usualy the encoder but it usually spikes rather hard in one spot. You can see this physically and by

Omniflo 5 high temperature warning

Electronics Forum | Wed Sep 03 07:39:19 EDT 2008 | pjc

You may not be getting enough exhaust pull, so the cooling modules over temp. Try swapping blower motors to isolate that before buying one. STANDARD AIR OPERATION: - Load-end: 150 cfm (255 m3/hr) at the 4� (102 mm) stack (minimum requirement) - Unlo

  1 2 Next

omniflo motor searches for Companies, Equipment, Machines, Suppliers & Information

Thermal Interface Material Dispensing

We offer SMT Nozzles, feeders and spare parts globally. Find out more
SMT feeders

High Precision Fluid Dispensers
Electronic Solutions

High Throughput Reflow Oven
Software for SMT

World's Best Reflow Oven Customizable for Unique Applications