Electronics Forum: omniflow (Page 1 of 10)

omniflow 5 iemme 760

Electronics Forum | Thu Aug 11 10:21:40 EDT 2005 | leonb

HI all, i have 2 omniflow 5 zone reflow ovens would these be suitable for rohs compliance also 2 iemme 760 reflow oven with 4 upper zone and 4 lower zones would these be suitable also any feed back would really help

Reflow oven omniflow 10E

Electronics Forum | Mon Feb 28 21:42:27 EST 2022 | emeto

Wow this is 21 years old! Impressive.

Reflow oven omniflow 10E

Electronics Forum | Fri Mar 04 12:29:04 EST 2022 | stephendo

The Historical Society. 20 years old is antique for technology.

Reflow oven omniflow 10E

Electronics Forum | Wed Feb 23 14:46:52 EST 2022 | astarotf

Hello everyone! We currently have a 10 zone oven, omniflow 10E, the CPU hard drive is bad and we don't have the installation files! neither the software nor anything. Does anyone know any contact or information related to this oven? I am looking fo

Reflow oven omniflow 10E

Electronics Forum | Thu Mar 03 20:19:28 EST 2022 | astarotf

If our hard drive had scratches on the data lens, the needle was misaligned and caused the drive damage. The disk cannot be recovered.

Reflow oven omniflow 10E

Electronics Forum | Fri Mar 04 10:44:54 EST 2022 | bukas

i got 14 machines from 1994 to 2001, where do I apply for medal? xD

omniflow 5 iemme 760

Electronics Forum | Thu Aug 11 16:20:54 EDT 2005 | pjc

I have seen good results on OmniFlo 5 for Pb Free solderpastes PROVIDED the boards are low to medium thermal mass and have no high conveyor speed (high production) requirements. Max peak temp you can set on O5 is 280C, enough to get 230C on-board tem

Reflow oven omniflow 10E

Electronics Forum | Wed Mar 02 22:11:30 EST 2022 | travishemen

I have successfully revived a dead hard drive by buying an the exact same model and swapping the circuit board from the new an presumably good hard drive to the drive I'm having trouble with. I have done this twice on hard drives that were between 1

Electrovert omniflow 10 speed control fail

Electronics Forum | Wed Apr 24 12:54:36 EDT 2013 | smtventasmex

Hi i working now on electrovert omniflow 10 tha deos not control the speed of the conveyor on the sofware, i did change the encoder but this ones continue failing, this fail start because we have a short cut on smemma wire, any one have experience wi

Electrovert omniflow 10 speed control fail

Electronics Forum | Mon Apr 29 01:29:29 EDT 2013 | aemery

If your current problem with the conveyor speed was caused by the SMEMA issue, maybe you have a Board #1 problem. The SMEMA communicates to the computer through Board #1. The input signal from the speed encoder and the output analog voltage to the

  1 2 3 4 5 6 7 8 9 10 Next

omniflow searches for Companies, Equipment, Machines, Suppliers & Information



High Speed Precision In-Line SPI System - Mirtec MS-11
Benchtop Fluid Dispenser

World Source Equipment: Used equipment sale. Hundreds of items on sale.
Best SMT Reflow Oven

Stencil Printing 101 Training Course