Electronics Forum | Mon Apr 08 07:20:56 EDT 2013 | leemeyer
What operating system are you using ? I have found that you need to stay with a DOS based operating system. I am running DOS 6.2 with windows 3.11. I tried win 98 and although it seemed to run properly, I would have problems in the final program. XP
Electronics Forum | Tue Apr 09 14:54:22 EDT 2013 | christian01976
Hello! I dont know where you are from but here in Germany Assembleon stopped selling Yamaha machines. Yamaha now sells their machines on their own. The things I know: Yamaha YS24 is equal to Assembloen MC24 Yamaha YS24x equal to MC24x YS12 is MC12
Electronics Forum | Mon Apr 29 12:32:18 EDT 2013 | stephendo
Do you watch when it is doing the wave height test? Watch it and see if it goes up to the same spot on the test probe each time. If the test probe is dirty sometimes the solder has to go up higher on it before it gets detected. You might actually be
Electronics Forum | Tue Apr 30 05:05:16 EDT 2013 | pavel_murtishev
Colleagues, Now I am involved into plant ramp-up where 3x Panaconic NPM-W will be installed. New production hall is being designed right now and the problem is that constructors have never met SMT shops and know very few or next to nothing about requ
Electronics Forum | Mon May 13 11:20:06 EDT 2013 | emeto
From what I have read about the topic, recommendation is to use flux for fine pitch BGAs. Printing is difficult because of the small pads. HEre is the moment where you have to make your calculations. Do you have enough assemblies that will use
Electronics Forum | Wed May 15 15:58:11 EDT 2013 | rgduval
Let me see if I understand you correctly. You have a batch washer (looks like a dishwasher). There is a top and bottom spray fixture, which would normally spray water up at the board and down at the board being washed. When you place boards in t
Electronics Forum | Fri May 24 09:34:57 EDT 2013 | markhoch
I run the same profiles for Top and Bottomside assemblies for all of my products. Only in rare instances have I been forced to run a profile with cooler bottom zone settings. This was obviously driven by assemblies with heavier components on the bott
Electronics Forum | Mon May 27 15:11:25 EDT 2013 | ericrr
Interesting, I could not find anything via a website search some of the links came up as 404, others a "home" page and some never went at all (or took too long) So I turned to google and found http://www.smtinfo.net/docs/tombstoning.pdf a 16 page a
Electronics Forum | Mon Jun 17 19:10:04 EDT 2013 | hegemon
You have not mentioned exactly how the BGA was reflowed onto the board. Was it sent through the oven again after the mini-stencil, or was it heateed up and reflowed using a BGA rework station, or other hot air device?? From the sound of it (outside
Electronics Forum | Fri Jul 26 13:11:06 EDT 2013 | gallionc
I think we are all on the same page with this one. Since you ran from 96 until now without any issue I'd say that now you know what causes the problem, make a note of it for next time and move on. I have found with our older machines that "if it ai