Electronics Forum | Wed Feb 01 10:13:50 EST 2006 | bsteffen
I know exactly what you are going through. One example, I needed a flux pump assembly. Vitronics price, about $1000.00. Going through the OEM (Fluid-O-Tech) the same assembly was $218.00. Oh and God forbid that you actually have to call Vitronics an
Electronics Forum | Wed Feb 01 15:54:07 EST 2006 | Rick
I need to place one type of part (0.080x0.017x0.010 inches) on a flat wire with an accuracy of about +/-0.010 in any direction. Volumes to be about 500 to 1000 per day. Are there any relatively small pick and place machines available?
Electronics Forum | Thu Feb 02 15:46:31 EST 2006 | MazinK
Hello Bobpan, Thanks for the reply. Please I need help, we have a quad machine here (QSV1 PLUS) and had problem Not INitilizing the machine, and keep give a message says, (( BUFFER FULL IN LINE 4), and FACTNET.CPP LINE 4. Quad saying could ne one of
Electronics Forum | Tue Feb 07 11:52:06 EST 2006 | slaine
Hi not bought fans from them ive sent failed ones off (usually siezed solid) and had them reconditioned. Theve run with no problems. Address of Furness Winding Co Ltd Kings Works Kings Road Ulverston Cumbria LA12 0BT Telephone and fax Tel: (01229)
Electronics Forum | Wed Oct 11 12:50:48 EDT 2006 | Frank R.
I work with this ESV-304 inline machine. We had a lot of problem with software (library) but now we know enough bugs to be able to create new parts without problem. Last week I went to a company that use a Yestech and for sure it's nothing compare to
Electronics Forum | Tue Feb 14 03:58:17 EST 2006 | Rob
Yes, it's fine - as Pete says you have to replace certain parts & either get the pot recoated or a new one. We ran a "Lead free" 6622C from Vitronics Soltec on Tin Lead, then it was cleaned up, recoated and loaded with a no-lead alloy with no proble
Electronics Forum | Wed Feb 15 04:59:16 EST 2006 | tk380514
these holes are non-plated they are for light pipes and the tolerances of the PCB manufacturer are 0.05 mm so the light pipes are small for the holes. Do i need to change more than this one file i have or do i need to change NcDrill files as well. As
Electronics Forum | Fri Feb 17 11:01:47 EST 2006 | amol_kane
with lead-free solders, one would expect to find less instances of tombstoning. this is because SAC alloys are not eutectic and melt over a range of temp (usually 217-220 deg C) instead of at a single temperature. therefore the forces due to solder s
Electronics Forum | Fri Feb 17 14:32:53 EST 2006 | gipos
Hi all, The question for experienced operators: DEK 260 or DEK 265, which one is more suitable for high mix low volume to mate Juki 700 series line ? Is there any specific known issues regarding service, operation, repeatability... ? We have target
Electronics Forum | Tue Mar 07 11:13:04 EST 2006 | pjc
One difference with ECD from a hardware standpoint is that the M.O.L.E. installs into the OvenRIDER, WaveRIDER and ReworkRIDER products for solder machine process control. You get the same software too. Competitive systems I believe require more hard