Electronics Forum | Sat Jun 05 08:45:30 EDT 2004 | vinitverma
Hi Adrian, You need the UFOS program. If you send me the cad data, and the BOM, and the board layout, I can make a sample program for you to check. However the program shall not be optimized and the head nos., feeder nos., and the vision files will
Electronics Forum | Wed Jun 16 21:56:04 EDT 2004 | rodionp
For those who are not sure as to what exactly we do, please get familiar with the article: http://www.reed-electronics.com/semiconductor/index.asp?layout=article&articleid=CA71291&industryid=3026 Which is PCB Assembly Optimization, what we do is we
Electronics Forum | Tue Sep 28 05:04:10 EDT 2004 | grayman
In obtaining almost zero defect in solder wave. I would like to suggest the following: First,We must consider changing machine if it is more than 5 years old. second, use the right tools for the right job. Most of the traditional engineers will us
Electronics Forum | Thu Feb 02 16:51:32 EST 2006 | fasst1
Greg, FYI, the concept of the Comet is that 1/2 of the board is populated on each table. This is in an effort to reduce the total transfer time hit per board. The on machine optimizer should be able to handle the split of the program. If you need
Electronics Forum | Fri Mar 24 12:57:08 EST 2006 | wbartley
It sounds like a theta problem, you could have a bad theta motor or driver. Does this happen during warm up? And you can try and disable one head at a time and optimize your program after each head is disabled and then run your program. To see if you
Electronics Forum | Thu Nov 16 09:45:51 EST 2006 | rgduval
I'm only peripherally aware of CircuitCam; we were adopting it in a past-life, and I wasn't terribly connected with the adoption. However, I thought that it did have the capability of optimizing a job to a production line (assuming the two machines
Electronics Forum | Mon Dec 11 15:26:20 EST 2006 | lrd116
Hello. Does anyone out there have any advice on optimizing a selective soldering process? We have a Pillarhouse fountain soldering machine new to our facility and as a Quality/Process Engineer, I am in charge of developing guidelines for board and
Electronics Forum | Mon Feb 19 11:43:53 EST 2007 | ck_the_flip
I've used ECD's WaveRIDER and TIC's Wave Optimizer, and some people have sworn by Malcom's wave reader as well (if you look at all the past threads). We HAD an optimizer here in our shop, but somebody bwoke it. :-( As for evaluating these, see Chu
Electronics Forum | Fri Aug 10 10:56:02 EDT 2007 | bentigano
Hey everyone. I'm looking for as much information as possible on the Universal 4796B chipshooter. We currently have a few 4785's, and are getting a couple of 4796B's next week. Mainly, I'm just looking for information on the NCZ file format that the
Electronics Forum | Mon Nov 17 06:27:50 EST 2014 | garym4569
In the program editor on the machine, you can output a text file of the production data. You can select to output placement data, component data, and/or feeder setup for the product currently loaded on the machine. You can also do the same in the H