Electronics Forum | Fri Sep 22 12:11:31 EDT 2023 | wippsen
Hi there, if there is insufficient Volume you may optimize the design of your stencil. Its not the goal to decrease the tolerances. Take the PCB and take a look at the printing Shapes with microscope or use the zoom in 3D Function. If there is too l
Electronics Forum | Tue Oct 18 03:34:48 EDT 2022 | sarason
Use PCBSynergy to do the file conversion to the machines you have and then use Ealead "Programming" to do the optimization. https://pcbsynergy.com https://ealead-e.ucoz.com/index/products/0-8 sarason
Electronics Forum | Tue Jan 18 12:36:11 EST 2000 | Dave F
Dave: I haven't located something to support your contention, yet, and I'm not going to comment on the factors that drive reliability beyond component selection, because I know that you've got some sweaty-palmed sales type wringing his hands waiting
Electronics Forum | Thu Aug 24 09:41:46 EDT 2000 | Dr. Ning-Cheng Lee
The optimal profile to choose is determined by the following factors, (1) thermal mass and distribution across the board, (2) reflow temperature range needed for a particular alloy, (3) the nature of flux. When the thermal mass is small, such as cell
Electronics Forum | Wed Nov 24 14:01:12 EST 1999 | Mika Johnsson
We did a survey on CIM optimization systems in electronics assembly. Our main stress was on optimization aspects. Here are some links from our study. Aiscorp, CIRCUITCAM http://www.aiscorp.com/ Dareba Corporation, http://www.magma.ca/~dareba/ Fabmas
Electronics Forum | Tue Mar 30 11:39:59 EST 1999 | Stefan Witte
| Hello, | | I'm a student assistant in a research project that deals with the simulation of PCB assembly systems. At the moment I collect information about SMDs. | My problem is how to assign the correct feeder width to various devices in a simulat
Electronics Forum | Mon Aug 31 10:28:11 EDT 1998 | Patrick O'Connor
| | | | Dew: | | | Is this the third or forth software alignment for Fuji? Hope they stick with Unicam for a period of time... | | | Just my two cents.... | | I believe it's the forth, MCS OS/9, MCXE,F4G, and now fujicam...were there any others I m
Electronics Forum | Tue Mar 05 07:56:32 EST 2002 | jax
I am not familiar with networking the machines in question. What type of OS do the machines run on? How does the Panacim software network the equipment? If you only want to access all the machines offline for file transport and do not plan on using t
Electronics Forum | Fri Apr 29 17:49:22 EDT 2005 | Woodsmt
I have used many of these devices recently and have used them several times over the last few years. I have been successful using a type 4 paste on a 5 mil stencil. The 13 mil round aperture should provide you with an area ratio just adequate for r
Electronics Forum | Fri Apr 29 17:49:26 EDT 2005 | Woodsmt
I have used many of these devices recently and have used them several times over the last few years. I have been successful using a type 4 paste on a 5 mil stencil. The 13 mil round aperture should provide you with an area ratio just adequate for r
.gif)
