Electronics Forum | Sun Aug 20 02:31:18 EDT 2006 | daxman
Last week, when we turned on our IP3, we received an error on our IP3, which read "Fatal Error with VP Turn Power Off" We had been running product the day before, and the day after we received this error. The function keys are locked and will not w
Electronics Forum | Fri Mar 23 09:07:55 EDT 2007 | oldsmtdude
Proper care and calibration of feeders helps the most. Once repeatability of position is gone the machine's feeder offset will start to resemble the agility of a drunken sailor. That can manifest itself in vision errors or worse as placement problems
Electronics Forum | Tue Oct 27 11:20:16 EDT 2009 | smtspecialist
I had the same problem back in March with my MY12, since I have two identical lines i swapped things around until swapping the x-wagon motor (the one for fine movements). When I swapped the x-motor I move the problem from one line to the other gener
Electronics Forum | Fri Jul 14 16:32:55 EDT 2023 | calebcsmt
Does class 2 vs class 3 PCBs effect variance/tolerance in terms of actual positioning of pads/traces? For example, if fiducial is to be at 10mm. What's the tolerance for class 2 vs class 3? [variance allowed] Does panelization have any effect on t
Electronics Forum | Sun Sep 09 14:34:50 EDT 2001 | darburch
Eric Whenever I see a board come out of the chipshooter missing parts the first thing to check is the support pins. However if you have checked table and part height I assume that you have also checked the pins. So the next thing to check is the vac
Electronics Forum | Mon Aug 06 10:03:01 EDT 2007 | slthomas
I agree with jdengler on the rotary table being skewed. You need a couple of dowel pins (1 1/2" long x 1/4" dia., I think) to align that disk. Each idler is held on an eccentric cam and can be adjusted to square up the rotary table by dropping the do
Electronics Forum | Tue Feb 21 10:45:45 EST 2012 | acsscott
Thanks for the password. There is a 7 pin connector for the Emergency stop in and out. It has a mate with a jumper wire attached to the Topaz end. If you put the jumpered mating connector on this, the emergency stop errors go away. The other conn
Electronics Forum | Tue Jan 30 10:43:18 EST 2007 | darburch
Before you do anything to the windmills check the heights in your PD's and if you are using board supports be certain that they are set correctly. The CP 65 has approx 1.8mm of travel before the pin will get stuck, as the nozzle should only deflect .
Electronics Forum | Fri Jul 10 19:53:31 EDT 2015 | tamazula
make sure noting stock in the X ,and motor brake > work usually machine supply 24V to motor brake > wire for release brake then move until hit the > end stopper for init motor if brake keep on > that will the error message > > i got it ofte
Electronics Forum | Mon May 16 11:45:35 EDT 2005 | PWH
Agree with PDE. We have two GSM's and we get this error often. Palm down e-stop when you get this error message. Machine will drop nozzle bank down after doing some segment repairs. Open covers and make sure nozzles are seated in reference to ali
