Electronics Forum | Mon Nov 05 01:31:58 EST 2007 | jmelson
Well, that was a bit of a lucky guess. There are a number of things that can cause that message, and the programmer of the system DID have enough information to make the error message a LOT more specific if he'd wanted to. When machines cost what t
Electronics Forum | Sun Nov 04 19:13:25 EST 2018 | cirsol
Thanks. Have tried registering again and sent ASM an email. Since my original post I have been able to locate the user manual with schematics etc, but the documentation that I have is still quite lacking in terms of troubleshooting and defining machi
Electronics Forum | Wed Jun 21 09:23:28 EDT 2006 | rmitchell
problem solved. Some PCB table support pins were jammed down in the table preventing the Z axis from lowering all the way. The intial error mesage was x and y servo, but the real error was the z axis overflow. Rob
Electronics Forum | Fri Jul 19 18:21:17 EDT 2013 | microaide
We recently purchased some used Quad 4C machines. One of them does not seem to keep a stable origin reference point. I teach the nozzle and component pickup coordinates, then suddenly everything seems to be off by .030 to .040 inches in the X axis. I
Electronics Forum | Tue May 21 07:03:14 EDT 2002 | smtexpert
Hi, My Tenryu 5500 is showing "X OVERRUN" Error while performing Origin. Can anybody tell the probable reason. thankyou. Priyaranjan
Electronics Forum | Tue Sep 17 05:19:48 EDT 2013 | engineering@smtxtra.com
Hello, its simple the Panasonic tape is encoded, the non original splice tape you try to replace is not coded hence error on feeder sensor. we offer Panasonic replacement splice tape, for a sample please contact the office, hope this helps Robi SmtXt
Electronics Forum | Thu Sep 26 05:23:51 EDT 2013 | bobpan
Does the original 'bad' SRX card work in the other machine? If so....then both boards are good and you have another problem. I would go through the list i posted above on motor error 4 problems. I would suspect a ribbon cable or motor/motor cable at
Electronics Forum | Wed Mar 07 19:07:36 EST 2018 | magergar
I have changed the FRQ Amplifier with the FQ amp that has the same parameters and the error persist, the Zero Setting Sensor and the Clutch Origin sensor are working too. Any other posibility?
Electronics Forum | Tue Oct 26 00:03:09 EDT 2010 | jmelson
Hmm, that's a fairly old machine, even older than mine! (I have a CSM84 PA130640). Anyway, it is best to program the machine from CAD system data, I wrote a little program in C to read in the component type and XYR position, and produce the file in
Electronics Forum | Sat Jan 20 23:48:55 EST 2007 | bvdb
Hi Al, Thanks for the suggestion. Yes, I should have said that the cable has been checked and another cable tested with the same results. In addition to the three wires that carry the transmit data, the receive data and the data signal ground, the