Electronics Forum | Fri Jan 25 05:22:47 EST 2008 | dekiper
Hi, You could try other types without brass shim. It's also important to use a good tool that is adjusted properly. Contact me and I will help you with quality samples and instructions. http://www.dekitools.com // Per Gester
Electronics Forum | Thu Jul 14 10:29:53 EDT 2005 | stepheniii
It can be used as a sales tool. Choose a CPK you want, then "adjust" your definitions and limits untill you achieve that. Just be prepared to explain that someone who is unavailable for explainations set up the SPC system, and you are just following
Electronics Forum | Fri Mar 03 13:51:17 EST 2006 | Chunks
We've looked at our stencil under magnification after hand cleaning. There is some paste left behind. Machine washing removes all of the paste. Your best bet is to clean like normal, then look at the aps under magnification. Adjust accordingly (a
Electronics Forum | Wed Aug 23 14:59:32 EDT 2006 | bill
I�ve been lurking on the forum for a while so I will take a stab at this, mainly because there is no answer I take it that you have a variety of boards being produced at the same time and are in fixtures so the conveyors don�t need to be adjusted, a
Electronics Forum | Mon Dec 17 12:06:58 EST 2007 | pjc
5 Steps to Eliminate Bridges: 1. Establish (wave) Parallelism First and foremost, you must establish board-to-wave parallelism. This is the prerequisite to any wave solder process control. For an understanding of the power of this approach go to ht
Electronics Forum | Mon Jun 08 14:19:30 EDT 1998 | Gary Simbulan
Earl, et al, Boy things get old and cold around here fast. I promised more detail on my capactior problem and I thought I could drop something completely different in the same message and tell a tale of solder balls. First the caps. We still have
Electronics Forum | Thu Mar 28 15:53:49 EDT 2019 | SMTA-Jon
As a CM, we don’t have a lot of input on the PCB layouts we receive. Some engineers/software packages output the paste layer 1 to 1, some do an across the board reduction, and some set each part up individually with different reductions per footprin
Electronics Forum | Thu Jul 03 08:53:27 EDT 2008 | rgduval
I would...and then use the data of the known issues as part of the secondary analysis. The defect is a defect, one way or the other. You can use the secondary analysis of your PPM numbers to continue to drill down in the process. If your overall P
Electronics Forum | Wed Nov 29 01:09:17 EST 2006 | Guess
I would suggest checking the feeder, MVF and MSR are both turret type and dont have the capability auto pik adjust in y. Y offset pick up would lead to : 1. Over turn component. 2. Missing component. Turret sequence is pick, recognize an
Electronics Forum | Sun Nov 08 15:27:25 EST 2015 | davef
Thinner: Flux thinner, NOT paint thinner We kept a spare stone in thinner in inventory. We cut PVC pipe to size, cap in one end, screw thread on the other, stone inside, filled with flux thinner and covered with a screw cap. I don't remember who we
