Electronics Forum | Fri Jul 15 13:28:55 EDT 2005 | Brian
A process consists of much more than just thee machine. When developing a cause and effect diagram ffor the process, there are many parameters that fall outside the machine itself. There are Man, Machine, Methods, and Materials. Just monitoring th
Electronics Forum | Tue Aug 23 22:09:50 EDT 2005 | Ken
You can put a 15, 32, 45, 54 mm lens on a Topaz. However, the 54mm has no published specs. Standard config would use the 45fov single cam. Remember the larger the fov the lower the resolution. Oh and for you guys out there who like the parts per
Electronics Forum | Fri Aug 12 22:10:24 EDT 2005 | Mika
I agree with all the prior postings! But I have some additional thoughts about this. If there is a build up of moistures (% humidity) inside the pcb; before you reflow the pcba; then you will have the result out of the oven, just as you described. My
Electronics Forum | Wed Aug 03 14:11:03 EDT 2005 | mgc
This problem is not unique to China. Second user customers are always challenged to assess machine condition, upgradeability, service history etc. More often then not, candidate machines are located halfway around the world. Further complicating thi
Electronics Forum | Thu Aug 04 07:13:42 EDT 2005 | stefwitt
All good advise, guys. I somewhat blame myself, that I didn�t inspect the machine. On the other hand, who knows, what machine I would have seen. Here are some e-mail responses, indicating, that this is not the type of business I�m capable of doing my
Electronics Forum | Thu Aug 11 08:53:40 EDT 2005 | stefwitt
I�ve seen new table-top machines for $ 15,000 at exhibitions, but only one time and the same vendor didn�t show up the next time. Realistically, new machines capable of doing 0402 and 20 mil and a few kpph under $ 15,000 do not exist. Any used mach
Electronics Forum | Sat Aug 27 12:45:44 EDT 2005 | Mark
Thanks for the replies. Interesting white paper. Didn't quite answer my concerns but still a good read. I was actually surprised that to test temperature uniformity across the zone, they attached T/C's to the substrate rather than measure the ai
Electronics Forum | Thu Sep 15 11:28:11 EDT 2005 | LeeHoMa
hi Steve/Pete, Thank for your email to affirming our current mounting and soldering flow! In fact, I also don't see any problem for the pilot run(though in small volume - 500pcs). However, the problem is - I am challenged by my customer that the AI
Electronics Forum | Mon Apr 24 14:04:44 EDT 2006 | pjc
You did not tell us where your boards fit on the thermal mass range. That is key. I've run Pb Free low to medium thermal mass boards with good results on a 5 zone oven (5 top/5 bottom). You should not have a problem running a medium thermal mass boa
Electronics Forum | Wed Sep 21 12:30:03 EDT 2005 | Rob
Hi Greg, We've used lots of machines over the years & seen lots of different tape related issues - the main one being snap off of the cover tape, usually due to too much glue, over entusiastic heat seal, or a feeder requiring maintainance. Also the