Electronics Forum | Thu Jun 01 21:13:48 EDT 2006 | jacksaria
Hello EC, Throw out is sometimes after and before. My msn account is j.saria@hotmail.com. regards,
Electronics Forum | Tue Jun 06 16:50:33 EDT 2006 | pjc
Push Back !! Check out this article: http://www.circuitnet.com/web/article_20181.shtml
Electronics Forum | Mon Jun 12 12:47:31 EDT 2006 | proy
Customer requires 10 E 13, then humiseal applied to take air out of the equation. This is primarily required on a 1Meg High Voltage resistor divider PR
Electronics Forum | Wed Jun 14 15:17:15 EDT 2006 | Chunks
We too have run different pastes and found similar results. I do not repsond to this post to help the Doctor out.
Electronics Forum | Mon Jun 12 10:34:06 EDT 2006 | cuculi54986@yahoo.com
My brother-in-law is a DDS and I trust him. We had some problems with solder voids in the past, and he was invaluable. He'd drill them out and fill them with SAC3240X+.
Electronics Forum | Mon Jun 12 10:46:38 EDT 2006 | Chunks
It's hard to believe MoonMan spends this much time typing these rants. Guess the boys at ever so much higher I.Q. standard of engineering, IPC, kicked him out there too.
Electronics Forum | Tue Jun 13 13:07:40 EDT 2006 | patrickbruneel
I just found out that no changes can be made to the petition by anyone because of the audit requirements. When time comes to do the adding up duplicates will be removed before submission.
Electronics Forum | Mon Jun 12 22:11:11 EDT 2006 | danielchankh
Is there anyone out there who has used fringe pattern image projection vs laser triangulation method for solder paste volume inspection? Need some advice on which is better?
Electronics Forum | Tue Jun 13 13:42:34 EDT 2006 | Bob R.
Also be careful in assuming you have black pad. A nice straight crack along the Sn-Ni intermetallic is probably just overstress at some process (most likely ICT). The better board suppliers figured out how to avoid black pad years ago.
Electronics Forum | Thu Jun 15 16:24:19 EDT 2006 | patrickbruneel
I have to make a correction to my previous post There are specialized inks with cadmium pigment The easiest way to find out is to get an MSDS from your supplier and check for the presence of cadmium (which is a banned substance under the EU RoHS dir