Electronics Forum | Tue Jul 13 11:21:28 EDT 2021 | stephendo
You may have to use an adaptor board. A small board with one footprint on one side and the other on the other side. Do not assume that the pin outs of the two parts are the same. I have seen smaller parts with a different pin out than the bigger part
Electronics Forum | Wed Sep 01 02:48:49 EDT 2021 | cmchoue
Hi Experts, I'm looking for how to auto skip the AXI(X-Ray) inspection on X-out board,Did any folks have the experience on this? Looking for your advice. AXI machine,Virtox and Matrix Thank you CM
Electronics Forum | Mon Nov 01 09:56:57 EDT 2021 | richardcargill
Update - Solved On talking with BTU they mentioned that if the conveyor is always running full speed then cleaning out the motor brush area with compressed air will cure it. I'm guessing that the carbon dust had encroached onto the encoder. A good b
Electronics Forum | Wed Jun 15 19:46:15 EDT 2022 | mikevb
Hey All. I figured it out. It turns out that the problem was simply a loose coupler on the x wagon motor transducer. I had only checked one screw in the past but the other screw was apparently loose as well.
Electronics Forum | Thu Jul 14 08:32:43 EDT 2022 | bobpan
Sounds to me like the motherboard is on its way out. Go to my website at http://www.precision-repairs.com to email me and i can try to help you out. The version of the rt motherboard would help some also. Bob
Electronics Forum | Thu May 18 15:51:51 EDT 2023 | curtfo
I am designing a tape and reel system for a customer that want automatic reel change. Are there any products out there for automatically changing out the reels on a tape and reel machine?
Electronics Forum | Wed Dec 20 13:40:53 EST 2023 | bobpan
the glass is to keep dust out. Now that it is off the dust is already in. Leave the glass off and just run it. If you have a problem 6 months down the road then take dry air and blow it out.
Electronics Forum | Tue Apr 23 09:22:02 EDT 2024 | wippsen
of course it has an impact on line capacity. x-out boards have a shorter cycle time, but you have to push more panels through the line to reach the order quantity
Electronics Forum | Sun Dec 09 22:54:20 EST 2001 | dburr
It sound you have already discovered to root cause, flux entrapment in the via holes. Short of changing the desing, here are sone suggestions. The main thing is you have to dry out the via holes of the wet flux. Some things to try are: slow down t
Electronics Forum | Wed Dec 05 22:59:42 EST 2007 | er_pe
To be successful, and to yield quality products off any selective solder systems out there on the market today, DFX rules need to be enforced and followed. Lay-out is a one-shot process where as manufacturing of the PCBA is continuous. Obviously, muc
