Electronics Forum | Mon Aug 31 19:53:17 EDT 2020 | inspiredmorris20
thank you both, We removed the connections and cleaned them. unfortunately no success, we are testing the conveyor interface board to see if we have a bad board. additionally we found that power supply #3 and #4 do have 110v going in but do not have
Electronics Forum | Tue Sep 01 11:53:21 EDT 2020 | inspiredmorris20
bukas, Yes, as soon as the software loads it immediately throws a 0002 (front E-stop pressed) and will not come out of EMER mode until i stop, reset, ready, on the control panel. yesterday however it also threw a E100 I/O I/F board communication d
Electronics Forum | Tue Sep 15 14:42:20 EDT 2020 | kumarb
Some threads that may help: https://electronics.stackexchange.com/questions/398199/filter-harmonics-in-ac-power-line still recommend that you contact Heller for advice. Consider to insert a UPS system between your hydro and one of the LED light fi
Electronics Forum | Mon Oct 12 17:25:09 EDT 2020 | rgduval
Release the e-stops :) Chances are pretty good that one or more of the e-stop switches is going bad. Pop them off, and measure with an ohm-meter to figure out which one it is, and replace. I don't recall anything in the software that identified wh
Electronics Forum | Thu Nov 19 11:45:53 EST 2020 | sarason
You can still restore the data from a failed HDD like this. There a HHD recovery companies that will take the platters out and place them in another drive to extract the data. ALso on Youtube you can find Louis Rossmann in NYC that does these repairs
Electronics Forum | Fri Nov 20 19:53:13 EST 2020 | stevedb321
Hey everyone, I finally got enough of a document for the Viking wafer map format that we were able to decode the binary files. We were able to guess about 90% of the contents (By guess, I mean suss out) but for binary files it's 100% or nothing. Th
Electronics Forum | Thu Dec 03 15:31:12 EST 2020 | spoiltforchoice
And for the purpose of completeness you can also use: GC-Prevue Pro Fab3000 GerberGrab VisualPlace The last two are free but the best method of all is to tell whoever made the gerbers to generate the Centroid file too. There is literally no excus
Electronics Forum | Sun Jan 17 10:27:01 EST 2021 | ecogroup
Thanks for replying Bukas...few days prior we found out it was the conveyor IF board. Changed it, all the contactors now engage. But now have these errors: Opened [SYSTEM] file is created by #1 machine. No command resonse from handler. (0x1000)
Electronics Forum | Wed Jan 06 11:05:13 EST 2021 | greezmky
Thank you rtmitchell, being unfamiliar with the system, I missed that the end is slightly nicked. I pulled a dog out of a machine that has been cannibalized, I verified that it was straight and not nicked, and installed it in our production line mach
Electronics Forum | Mon Jan 11 17:19:31 EST 2021 | rmitchell
Problem resolved- The machine camera had crashed when the operator put the PCB in upside down (this was kept secret until intense water boarding). The crash seem to take out a chip on the vision processing PCB. It was visually damaged and looked lik