Electronics Forum | Sat Jun 05 07:47:47 EDT 1999 | Dave F
| | | Has anyone had a problem with the trailer tape length being too short and causing placement machine to stop for parts exhaust (SMT parts)? I realize the EIA spec. is set for this length but would like to know what issues you have had. Thanks
Electronics Forum | Mon May 10 14:52:32 EDT 1999 | C.K.
| | | I left the company before this thing ever got resolved, so I don't know the answer, but here's what we did to get boards out the door. Baked them in a desicating oven. You know, the kind that pulls vacuum? It was a regular overnight process
Electronics Forum | Wed Apr 21 19:42:12 EDT 1999 | Jeff Sanchez
| | I would like to protect my SMTNet e-mail account from others who use my system. I can't seem to find the pass word feature. Although I do incurage going to the site on my system I don't like the idea that everyone can go through my e-mail. | | J
Electronics Forum | Tue Feb 23 11:09:12 EST 1999 | Steve Gregory
Hi Dave! Dat' be da same board we ran at NEPCON East in 97'! Ray Rua was running the TAC line then (his company usually runs the TAC line at almost all NEPCON shows). A couple of things I wanted to point out on that GIF image that might b
Electronics Forum | Wed Jan 20 14:21:54 EST 1999 | Dave F
| I need some opinions (And I know everybody has one). | I am mounting a board into a case, after mounting the board | I am loading it with stress in the middle causing it to bend around .030 inch. The board is 4" X 6" and is Bending in the 4" dire
Electronics Forum | Mon Jan 18 17:58:09 EST 1999 | marc p
| I have a severe problem with flux residue being drawn up the vent ducts of my reflow oven. This residue reaches a critical mass then begins to flow down the ducts and becomes very messy. I run a no-clean process and use IR oven. Has anyone else o
Electronics Forum | Mon Dec 28 20:34:38 EST 1998 | Chris Grendler
| | Any one know a good stencil vendor who can produce stencils below .002" foil with appetures at .004" on .008" pitch? AMTX use to be my vendor but they are closed down. | | | | Thanks, | | | | Chris Grendler | | | Chris: One source of e-for
Electronics Forum | Fri Dec 18 10:00:19 EST 1998 | Chrys
| Does anyone out there have one we are currently looking at one from a used equipment dealer and would like to know how they work? Good or bad for SMT? | Good or bad for high volume Thrue Hole? | | Thanks Again, | Brian Steelglove | American Prec
Electronics Forum | Fri Dec 18 12:14:10 EST 1998 | Brian Steelglove
| | Does anyone out there have one we are currently looking at one from a used equipment dealer and would like to know how they work? Good or bad for SMT? | | Good or bad for high volume Thrue Hole? | | | | Thanks Again, | | Brian Steelglove | | A
Electronics Forum | Mon Sep 14 04:13:53 EDT 1998 | Jeff sanchez
| Thanks for the help, Guys. | As a matter of interest, I'm going to look up the standard and see if there's a European (or preferably UK) equivalent. If I find anything, I'll post another Follow Up (though I doubt it holds much interest for you)! |
.gif)
