Electronics Forum | Thu Mar 25 13:08:45 EST 1999 | Dave F
I have not been good at this and I assume others have not either, so I figure I'll mouth-off about it, even though I'm probably the only jerk on SMTnet that doesn't visit SMTnet Banner Advertisers. I believe that we need to visit SMTnet Banner Adve
Electronics Forum | Wed Mar 24 09:22:16 EST 1999 | justin medernach
| We might be doing a job with some plcc, soic on one side and the other side will have two BGA's. Does any one have any ideas on what knid of problems that might occur if we reflowed both sides? Like heat temp, surface tension, etc. Thanks for any h
Electronics Forum | Tue Mar 23 02:36:38 EST 1999 | Bob Willis
| Are there many of you who are soldering through hole parts in your surface mount reflow oven? How repeatable is the process? Do you need to touch up a lot after reflow? We don't do long runs maybe 200, 300 boards max. Can you just screen print
Electronics Forum | Sat Mar 20 18:48:53 EST 1999 | GSM GURU!
Hey, all you Pro's out there I am looking for someone that has worked with the Universal FlexJet. We have been Beta testing one for a couple of months now and are having problems with interfacing optimization software with it. I would like to know th
Electronics Forum | Wed Mar 17 22:04:05 EST 1999 | Dave F
| Looking for a company that makes a small batch reflow oven. Not a belt-style convection oven, but a cabinet style that can 125 c to 150 c. | | Thank you | Matt: The batch ovens we looked at were very difficult to program. They seemed to want t
Electronics Forum | Tue Mar 16 17:05:14 EST 1999 | Jeff Dahlin
We are having a small number (~2%) of our boards pass our manufacturing diagnostics, fail once they reach the customer, fail when they get back to us and then start working again after handling them for a short time. We have eliminated a lot of item
Electronics Forum | Wed Mar 17 09:32:35 EST 1999 | Dave F
| We are having a small number (~2%) of our boards pass our manufacturing diagnostics, fail once they reach the customer, fail when they get back to us and then start working again after handling them for a short time. We have eliminated a lot of it
Electronics Forum | Tue Mar 16 15:59:40 EST 1999 | GSM GURU!
| I am in need of feeder that that will feed a 76mm wide tape @ a 60mm pitch to be used on a Universal GSM. | It is not a standard tractor feed, so it would require quite a bit of ingenuity. | Does anyone out there know of someone who designs and bui
Electronics Forum | Mon Mar 15 16:01:06 EST 1999 | Earl Moon
| Does anyone have any recommendations on spray fluxers? Are there major differences between the high priced ultrasonic machines to the low priced flux/air spraying machines? We are going to be spraying an OA flux with 11% solids content. Are there a
Electronics Forum | Wed Mar 17 12:19:53 EST 1999 | Scott Cook
| Does anyone have any recommendations on spray fluxers? Are there major differences between the high priced ultrasonic machines to the low priced flux/air spraying machines? We are going to be spraying an OA flux with 11% solids content. Are there a