Electronics Forum | Thu May 02 15:29:19 EDT 2013 | jim_n_hky
I can't answer your specific question on the floor, but I have some suggestions. The equipment manufacturer should be able to provide the floor loading requirements. A structural engineer should be able to translate that into specs for hte constructi
Electronics Forum | Tue May 07 16:19:47 EDT 2013 | dyoungquist
The "25v reads 3V" part of the error message may be your clue. Since the machine runs for a while and then shuts down, something may be failing after it warms up. "F-AXIS-182:C-AXIS NOT properly out when expected" refers to the centering jaws not o
Electronics Forum | Fri May 17 08:43:46 EDT 2013 | fredcalkins
If you have Flexhead nozzles you need to be careful that whatever solvent you use does not attack the gasket adhesive. I might try a couple of drops of a spray like WD-40 or LPS. Let it soak for a few minutes and blow it out with compressed air. Repe
Electronics Forum | Fri May 31 18:00:55 EDT 2013 | hegemon
With regards to first picture.(Large themal vias) I would attempt to measure the area of the ground pad, less the area of the "drain" holes or Thermal Vias. From that result I would reduce the aperture to account for about 50% coverage of that remai
Electronics Forum | Wed May 29 14:17:01 EDT 2013 | ericrr
OK the plot thickens: Yesterday used brand new paste, as it comes out, nothing added. Did about 13 panels, (or about 60 wipes) extra wipes because the PCB registration varies from panel panel. SAME PROBLEM ~ SAME PLACE. Took all the paste off the s
Electronics Forum | Tue Jun 18 09:51:53 EDT 2013 | rway
If they're 1 1/2 years old, they are definitely aged parts. Either send them back for newer or widen your tolerances on the ICT to compensate. You are at the 3rd decade now (10,000 hours) and you will need to compensate for this. These parts are n
Electronics Forum | Wed Jun 12 13:27:28 EDT 2013 | joeherz
Our customer wants to do an overmold operation (3rd party to us) on the non-populated side of a rigid flex assembly. Their inquiry below: "We are going to end up over molding plastic over the back of this rigid flex to form an enclosure but wanted
Electronics Forum | Sat Jun 22 05:40:36 EDT 2013 | lkavan
Hi friends, I am sorry that I boring you again, but I hope somebody can help me... I have a problem with servodrivers Panasonic MSD5A3P1EA in my Tenryu MT5530. Some servo loops are unstable, motor is shaking. It is problem with driver, when I change
Electronics Forum | Fri Jul 19 16:27:38 EDT 2013 | microaide
I think I have the vision problems figured out. There were two problems. 1) The Alignment type was set to "Small" for my TQFP48 part. It should have been set to "Complete". This is a clear case of poor documentation. The AutoProgram manual lists the
Electronics Forum | Tue Jul 30 15:04:54 EDT 2013 | ericrr
Is it just possible that H49s crysats are hard to place, so it looks like it has been place by a perfectionistic instead of looked like it had a parachute type loading. This is the H49 short stubby type crystal about 10 mm long (width) about 4.5 mm