Electronics Forum: ovation grid-lock support (Page 1 of 2)

Board support

Electronics Forum | Thu Nov 08 07:45:03 EST 2007 | hussman

We use the Gel Flex from MPM. Made a different base for each machine. Works well for most boards, but you may need additional pin support for larger boards. No tools, no vaccum hoses, no missprints (which Grid Lock is famous for), and best of all

Board support

Electronics Forum | Mon Dec 08 17:06:54 EST 2008 | smellew

Hi Grid lock & others are ok solutions but i've tried them all the best system i received was from a company in eastern eu called cisoli ltd they supply support systems for DEK's MPM's and any placement machine i used them on DEK ELA Fuji CP642 & IP3

Board support

Electronics Forum | Thu Nov 08 05:55:38 EST 2007 | jola

Hi. We have a medium to high volyme production with a lot of different boards to run inour lines. We do some prototypes as well but not as our main production. We have a lot of change over time that we try to reduce and as far as it's not double side

Board support of Fuji machines.

Electronics Forum | Mon Mar 31 17:18:15 EDT 2008 | pstone

I am looking for idea�s for board support on Fuji CP642 thru CP742 and IP 3�s. We have tried using the Grid-lock system which worked on the IP�s but not on the CP�s. We have also tried using the Ready-set system and had the same results. We are gett

Magnetized Support Block

Electronics Forum | Wed Mar 27 08:07:42 EST 2002 | caldon

Ovation Products (devision of Airline Hydraulics) makes a fixture just for Screen printing and PNP machines. This product is called grid lock. It's tooling that is air actuated and conforms to the bottom side of your PCB with gentle (gentle enough no

How to place pin supports the same everytime a board is ran?

Electronics Forum | Fri May 25 14:59:45 EDT 2012 | kevslatvin

I too would go with something like the Grid-lock. We use Red-E-sets from production solutions. They are similar to the grid-locks but don't use air.

DEK supports

Electronics Forum | Wed Nov 10 18:12:49 EST 2004 | dorklover664

We are looking for a new way to support PCAs in the DEK. I am trying to push for getting grid-locks but have been told they cost to much. Right now we are trying out another support system (hell if I can remember what they are called) like the grid-l

DEK supports

Electronics Forum | Fri Nov 12 06:38:43 EST 2004 | clampron

Good Morning, I feel that the Grid Lock system (with stealth mode) is the best system for absolute support. For us, it came down to spending 5K or 30K. We went with the 5K. The system we got is not perfect but serves our needs. The Grid lock resets h

DEK supports

Electronics Forum | Thu Nov 11 11:22:29 EST 2004 | clampron

We are using the Red-E Sets on our DEK Infinities and they are working fairly well. There are some issues but the setup time beat the Form Flex and was more reliable than the Autoflex in our machines. We looked at Grid Lock. This seemed to solve all

MPM Momentum Grid Lock Tooling Manual Mode

Electronics Forum | Wed Apr 24 13:49:19 EDT 2019 | griinder

I have a support question concerning setting the gridlock tooling in manual mode on a MPM Momentum Elite. I am printing the top side (bottom is populated with parts) of a thin, flimsy PCB. The Grid lock tooling bows the PCB upwards in Auto mode, beca

  1 2 Next

ovation grid-lock support searches for Companies, Equipment, Machines, Suppliers & Information