Electronics Forum | Thu Jan 07 09:58:14 EST 2010 | kjs123p
Pull the hard drive out and use a USB to IDE adapter to copy the whole hard drive onto another computer. I do this with my reflow oven and screen printer. It works very well.
Electronics Forum | Tue Jan 19 21:30:52 EST 2010 | davef
Approaches are: * Thermal profiler that you use to calibrate your oven. * Any chromel-alumel [Type K] fine wire thermocouple with a cheapo instrument attached will do the job
Electronics Forum | Fri Jan 29 14:53:13 EST 2010 | phase1
We aquired this reflow oven some time ago and finally have the need for it. Anyone who knows how to set up this machine and train an individual would be greatly appreciated. We are located in the Rockville Maryland Area. Power is run to the machine.
Electronics Forum | Sat Feb 06 16:28:09 EST 2010 | mystkldy
I have some large ROHS SMT inductors that are moving during the reflow process. I have tried adding extra solder, gluing and doing both. I don't know what else to try, any suggestions?
Electronics Forum | Thu Feb 18 11:37:25 EST 2010 | dcell_1t
thanks for your replies, I will check about oven integrity (calibration) and any exhaust issue... as fas as I know there's not change or addition to exhaust system but I need to confirm.
Electronics Forum | Fri Feb 19 12:52:00 EST 2010 | dcell_1t
I have a debate here with Facilities maintenance dept. oven is asking for 550 SCFM and they are measuring 770CFM I know that is different SCFM to CFM... but I don't know the pressure. any thoughts on how to convert???
Electronics Forum | Mon Mar 01 09:36:29 EST 2010 | duanebrayton
Good morning Chris, We had discussed surface tension but were not sure if that alone would be enough, so I reduced the bottom side temperature in the oven by 20 degrees to see if that would help. I will be checking results this morning. Thanks f
Electronics Forum | Mon Mar 01 10:27:08 EST 2010 | wrongway
I don't think I would reduce the heat at all if there is no vibration in your oven or on the chain you should have no problem with them falling off or moving but you sure don't want a cold solder joint you no the solder joints are so easy to see go
Electronics Forum | Sat Apr 10 08:17:21 EDT 2010 | nagesh
Dear All, I have a problem with the BTU-paragon -150 reflow oven,with the heaters getting off with Overtemperature Alaram. But the actual temperature on board not exceeding the 255 peak temp. Pls. advice & thx in advance for your sincere postings. R
Electronics Forum | Tue Apr 13 08:49:42 EDT 2010 | cast2010
Hello, Do you know a method for measure the humidity of PCB? I try with a measure of the weight before and after a cycle in an oven... Thank you.
Reflow ovens for automated SMT PCB assembly, specializing in lead free processing and nitrogen reflow. The best convection reflow ovens on the market.
4 Vreeland Rd.
Florham Park, NJ USA
Phone: 973-377-6800