Electronics Forum | Mon May 13 03:12:47 EDT 2019 | reckless
For your operation you may want to consider this depending on the kind of boards you are doing. https://neodenusa.com/smt-reflow-ovens/neoden-in6 110V 3 Zone Smart Reflow Oven Neoden I don't think china ovens are truly industrial grade but you may
Electronics Forum | Thu Sep 19 15:39:16 EDT 2019 | qanalyst1
When baking parts at 90C that require 15 hours bake time with parts that require 25 hours bake time, is it acceptable to open the oven and remove the former (15 hours) parts and then continue the 25 hours cycle for the remainder of the parts in the o
Electronics Forum | Wed Feb 23 14:46:52 EST 2022 | astarotf
Hello everyone! We currently have a 10 zone oven, omniflow 10E, the CPU hard drive is bad and we don't have the installation files! neither the software nor anything. Does anyone know any contact or information related to this oven? I am looking fo
Electronics Forum | Thu Jan 08 11:06:40 EST 2004 | russ
If I read this correctly you have two identical ovens that were setup the same ie zone temps, fan speeds etc... when you ran the same board through each of them one showed a lower board temp. Is this correct? Is the temp of the board 7 deg. lower t
Electronics Forum | Mon Dec 27 18:44:14 EST 2004 | Mark
I am testing some BGA's (PBGA 30mm x 30mm) to evaluate the maximum ramp rate we can achieve in our reflow oven. Temperature is being measured at the body(top) of the component / not leads. After several trials (with various oven settings), the high
Electronics Forum | Mon May 14 09:04:58 EDT 2018 | raylawre
We are using ECD OvenRIDER to validate our reflow ovens on a weekly basis to have the data to show our customers that the board we ran 3 months ago saw the same oven condition as the one ran yesterday. Cp/ Cpk is calculated by ECD using a manually i
Electronics Forum | Sat Jun 17 09:09:15 EDT 2000 | Chrys Shea
Contact the adhesive manufacturer, or their website. Most adhesive suppliers offer two cure options - one with a belt oven profile and one with a box oven profile. The belt oven is usually a ramp and plateau of 120-150C for approx 2 minutes. The b
Electronics Forum | Fri Oct 05 08:35:52 EDT 2001 | Hussman
Hey Steven, Achieving the proper profile like you described does require you to engineer proper conveyor speeds and zone temps. Most conveyorized ovens have the inside of the ovens divided into zones. Each zone has a top and bottom heater that can
Electronics Forum | Tue Mar 05 20:00:47 EST 2002 | rwilliams
I have recently been handed all responsibility of our Reflow Ovens. Upon my inspection, I discovered that any possible device on the ovens that you would think would require calibration, has a sticker indicating no calibration required. The practice
Electronics Forum | Wed May 21 13:26:46 EDT 2003 | Brian W.
Something else to keep in mind when you reflow using an IR (non-convection) oven. IR reflow is more susceptible to variations in board mass and coloration than convection ovens. Hi mass areas and dark colored parts will cause more variation in your
Reflow ovens for automated SMT PCB assembly, specializing in lead free processing and nitrogen reflow. The best convection reflow ovens on the market.
4 Vreeland Rd.
Florham Park, NJ USA
Phone: 973-377-6800