Electronics Forum | Tue Sep 14 14:07:45 EDT 2010 | grahamcooper22
Hi Gani, HASL is normally very good for solderability providing there is a good consistent coating of HASL on the pcb pad. But it is not unusual to have a very thin coating of HASL on the pad and this is poor for solderability. You then have tin/copp
Electronics Forum | Thu Oct 07 08:13:52 EDT 2010 | remullis
I just swapped from the HASL to Immersion Silver mainly because the board house we use could not maintain consistency in keeping the pads level. I was constantly battling bumps and bad finishes on the pads. They are able to give me a consistent board
Electronics Forum | Thu Jan 13 10:30:40 EST 2011 | bdamico
Hello Scott, Simply program the side angle cameras as you would for any other device using the downward camera. For instance, solder joint inspection for a PLCC would utilize a basis window, bridge inspection algorithm and individual solder joint i
Electronics Forum | Fri Nov 19 13:07:01 EST 2010 | vmorina
Hello everyone, Talking to my boss today I was able to determine what we're really looking for in terms of reflow soldering. The company is not looking to do a volume run; we're trying to solder chips for prototype boards, which are currently done w
Electronics Forum | Wed Dec 22 18:16:46 EST 2010 | padawanlinuxero
Hello ! I have a problem with one of high runner, our board comes in a seal package with dessicant cant really tell you how much RH% is inside the bag, but our board does not spend a lot of time in the shelf just some days or a couple of weeks max,
Electronics Forum | Fri Jan 14 19:25:52 EST 2011 | sonofptolemy
Hello, I am coming here for some insight and advice. I currently have high volumes (around 40K-50K) PCB's being stuffed at a local stuffing house. We are growing and lately have been putting in more orders with them. The problem is the stuffing qua
Electronics Forum | Tue May 31 14:23:16 EDT 2011 | gosswald
I bought an “as is’ Quad IIC package a while back. The machine definitely has issues with the Quadalign Board. The ICs were literally falling off of the board. I am guessing when it was manufactured they did not get the PC board quite hot enough or s
Electronics Forum | Tue Jun 07 10:38:34 EDT 2011 | davef
Boots: Here's several methods for guessing at the amount of solder on your connection: * First, 'Down & Dirty' ** Assume that the solder is flat, which is reasonable since it's 'flattened' by the component package ** Assume 100% paste transfer from t
Electronics Forum | Tue Jun 07 20:56:47 EDT 2011 | aoiguy
Any and all input will be greatly appreciated. So here it goes. I'm having an issue where the cad I'm getting from customers is referencing pin 1 as the parts placement. This isn't an issue for surface mount, however the aoi machine that we have in
Electronics Forum | Tue Aug 23 16:48:29 EDT 2011 | jax
assuming Sn05Pb93.5Ag1.5 Without knowing what you are trying to solder, PTH or SMT, the time might not be that far off. Does that time include stripping, cleaning, plating the leads prior to soldering onto the board?... pre-tinning the board as well