Electronics Forum | Tue Apr 11 12:40:47 EDT 2006 | Chunks
Depending on model and/or series, each one has it's own specific manufacturing guidelines you must meet in order to get a successful solder joint. Then you must couple that to what your soldering process is. Assuming you are talking all thru-hole,
Electronics Forum | Wed Jul 08 00:12:20 EDT 2020 | duchoang
Interesting!. They don't look like voids as usual meanings. The "voids" take the whole size of pads. We built millions of BGA, never seen those before. Look like the pads refused to connect with solder paste and pushed the paste away. Pads contaminat
Electronics Forum | Tue Jun 02 08:30:30 EDT 1998 | Jon Medernach
I have to agree with Steve. If the problem is progessively worse the problem is the pitch conversion that was used, and I have seen it before. It may be masked by the solder paste which could be on pitch but after reflow the paste wickes to the pad
Electronics Forum | Mon Apr 22 18:45:07 EDT 2002 | Steve Townsend
Chances are your profile is fine. There is probably too much paste on the descrete pads. Consider reducing the aperture size of the stencil. Good luck.
Electronics Forum | Thu Jul 10 02:49:34 EDT 2003 | emeto
Hi! One technique: 1. Remove all balls 2.Make a mask(stensil)for reballing.The holes of the mask must be 0.8-0.9 the size of the pads. 3. Reball chips 4. Reflow chips Good luck
Electronics Forum | Fri Sep 19 12:55:33 EDT 2003 | russ
We usually use a pad that is the same size as the ball. And use a stencil thickness of 7+ mils. Why the teardrop? Russ
Electronics Forum | Tue Jun 08 15:04:06 EDT 1999 | JohnW
| | | Hi,my master | | | How to iron out such soldering bridge with below conditions: | | | 1.The component(Harness)lead pitch is 2.0mm,the lead length is 3.2mm. | | | 2.PCB width is 1.6mm.Pad size is 1.65mm.Its a single copper PCB | | | 3.using s
Electronics Forum | Tue Aug 04 12:32:13 EDT 1998 | Bob Willis
The design rules for solder thiefs are that the extra pads must be bigger than the proceeding pads to be worth while as a minimum guide the pad is 3x the size of the proceeding pad so if the pad is 0.030" the thief would be 0.090" wide. As steve has
Electronics Forum | Fri Feb 25 16:04:18 EST 2000 | Dave F
Sze-Pei: Are talking BGAs here? Flux type? Profile? Pad material? Aperture size? We won�t want to give people too many hints on what the problem is would we? BGA voiding is a function of materials, methods, environment, and human factors. Con
Electronics Forum | Fri Feb 25 16:04:18 EST 2000 | Dave F
Sze-Pei: Are talking BGAs here? Flux type? Profile? Pad material? Aperture size? We won�t want to give people too many hints on what the problem is would we? BGA voiding is a function of materials, methods, environment, and human factors. Con