Electronics Forum | Mon Mar 17 07:00:34 EDT 2008 | ectan5117
Hi, During SMT process, i found that solder splash on the gold pad. The distance between the COB pad with component pad is about 1.25mm. My question is what material can used to cover the COB pad without bringing contamination. And i am welcome to
Electronics Forum | Tue Sep 22 08:35:47 EDT 2009 | cman
Did you try pre-tinning your board on this suspect pad/s to see if it improved wetting/solderability prior to printing/SMT placement and reflow? Does the pad/s not soldering tie to a ground layer? I would connect a T/C to each pad of the same part an
Electronics Forum | Wed Sep 15 10:59:12 EDT 2010 | asksmt
Thanks for the valueable feedback, I have two questions 1. why do you have to extend the pad size ? is it okay if i keep pad size 2. I am currently using thermal pad size recommended in datasheet max value 4.2mm x 4.2mm, how much should i shrink
Electronics Forum | Wed Feb 29 06:33:49 EST 2012 | amitsindwani
Please define the defect in following conditions & link to IPC 610 clause/sub-clause no.: 1. 0603 component placed on 0805 PCB pad 2. 0805 component placed on 0603 PCB pad 3. 1206 component placed on 1210 PCB pad and 4. 1210 component placed on 1206
Electronics Forum | Mon Sep 19 21:35:54 EDT 2016 | shriram
Appreciate your suggestion. NSMD pads are used for this design, the anomalies we found are 1. the trace running between pads has a lesser solder mask height compared the other area of the pads. 2. the NSMD pads doesnot have a trench close to pad e
Electronics Forum | Wed Jul 08 16:28:25 EDT 2020 | duchoang
OSP board finish is the issue. With OSP microBGA board, we need to have enough paste (enough flux) on pads (small pads on BGA), also we need to have strong, more activate flux to get rid of Preservative layer on top of pads. In this case, the OSP did
Electronics Forum | Wed Feb 23 21:24:42 EST 2000 | Dave F
Chris: Whatever way you decide to define your pads, use the same type on the component and the board. Non-solder mask defined pad advantages: � No point-of-stress concentration at edge mask and solder ball � No CTE mismatch at edge mask and solder
Electronics Forum | Wed Feb 23 21:24:42 EST 2000 | Dave F
Chris: Whatever way you decide to define your pads, use the same type on the component and the board. Non-solder mask defined pad advantages: � No point-of-stress concentration at edge mask and solder ball � No CTE mismatch at edge mask and solder
Electronics Forum | Thu Dec 09 07:46:42 EST 2004 | davef
We did this for BGA pads, but have not thought about other types. So, this may or may not apply for those. Pad defined by:||Advantages||Disadvantages Non-solder mask||No point-of-stress concentration at edge mask and solder ball||Smaller pads have
Electronics Forum | Tue Jun 14 08:37:18 EDT 2005 | jdumont
Morning all, just took a look at a new board we just got in and the there are different pad areas under the same BGA. What happened is engineering uses wider trace sizes for some pads and those overlap when more than one go to the same pad. This caus
PCB Electronics Manufacturing Automation Software for EMS, OEM & ODM manufacturers. Over 3000 customers worldwide!
116A Research Dr.
Milford, CT USA
Phone: (888) 486-4246
