Electronics Forum | Wed May 20 17:56:51 EDT 2009 | dyoungquist
I have attached a pdf showing the dimensions for the QFN we placed. First, The pins on the part are not only on the bottom side but also wrap around to come up each of the 4 sides of the part as shown in the side view in the attached pdf. This i
Electronics Forum | Wed May 14 11:10:56 EDT 2008 | scottefiske
Anyone out there in SMT land know the premium you will pay by not accepting any X outs?
Electronics Forum | Wed May 14 11:29:56 EDT 2008 | dphilbrick
It varys like anything on the shop and the volume. We've seen as little as no charge to 10%
Electronics Forum | Wed May 14 11:35:04 EDT 2008 | scottefiske
We produce High mix very low volume Military assemblies. So a typical order mya be for 50 pcb's, at a 5 up array. Do you work in the fab shop? Scott
Electronics Forum | Thu Mar 31 15:53:23 EDT 2022 | stephendo
And pin outs of both. Once I saw a SOT-6 replaced with a miniSOT-6 (IIRC) The pin outs of the two parts were different. We did make an adaptor board and it wasn't too bad. We populated a panel of the adaptor boards, depanelized them and put them in t
Electronics Forum | Fri Jul 07 03:27:31 EDT 2006 | dougs
Hi folks, thanks for all the tips. We have run our first batch of these flexi boards now. I had the PCB suppliers make me some 1.6mm FR4 carriers to lay the boards on to carry them through the process. (1 flat & 1 with cutouts for the second side)
Electronics Forum | Mon Mar 06 17:17:13 EST 2000 | gary
I need a little help with RF and Rogers 4003 board material. My background was in digital and now I need to set up a new line to make small RF products (.5" x .5" or smaller). I want to find out about board platings, finishes/maskings and reasonable
Electronics Forum | Mon Mar 06 17:17:13 EST 2000 | gary
I need a little help with RF and Rogers 4003 board material. My background was in digital and now I need to set up a new line to make small RF products (.5" x .5" or smaller). I want to find out about board platings, finishes/maskings and reasonable
Electronics Forum | Mon Jul 08 13:49:10 EDT 2002 | msjohnston
HI, We are looking into expanding our current x-ray inspection from manually inspection one panel per lot to 100% automated inspection for all of our BGA and CSP builds. We have 100% manual inspection at the end of our SMT lines and we are consideri
Electronics Forum | Mon Jun 26 12:23:11 EDT 2006 | Rob
Yep, Book a holiday and let someone else sort it out. Otherwise e-mail me and I'll talk you through pallets, rigidisers, printer tooling, spray mount, Kapton tape, local fiducials (panels can strech & shrink) etc. Oh, yeah - for the connectors you
