Electronics Forum | Tue Dec 02 06:07:00 EST 2014 | sarason
A trick I used to use doing RF design was to have on the edge of a panel, a stripline that I could hook up to a Network Analyser to check board impedance. You could do this to verify if the fault is in the no wash process or a board manufacture proce
Electronics Forum | Mon Feb 23 14:58:01 EST 2015 | ercdave1
I found the solution to my problem. Since I don't have a manual for the machine. I had no idea how to change the system settings but by pressing the first 2 buttons on the left of the front panel I got the system settings menu and was able to change
Electronics Forum | Tue Jun 02 09:32:24 EDT 2015 | tnisbet
Have to tried an automated system such as a > Router or Press? > > _a class=roll > href="mailto:tom@goppm.com"_tom@goppm.com_/a_ Tom > Nisbet .012 Is too thin for our Press & Die. How are you fixturing the panel on your router ? Do you have a d
Electronics Forum | Mon Oct 26 10:56:00 EDT 2015 | dyoungquist
We buy stencils from Stencils Unlimited (stencilsunlimited.com) which is the sister company to PCB unlimited. Stencils Unlimited will be the ones making the stencil if you order the pcbs with PCB Unlimited. We have never ordered pcbs from them so I
Electronics Forum | Tue Aug 23 18:12:15 EDT 2016 | jasltd
Hi Folks, I'm looking for suggestions for a label applicator to go in line with our SMT equipment to place both 2d & std bar code labels onto panels. The equipment needs to be easy to set up and flexible as we are a CEM so have a range of products i
Electronics Forum | Sat Nov 05 20:04:40 EDT 2016 | sarason
You would be better off setting a new fiducial using a pad or other feature that would serve that purpose. If the board has not etched correctly, it is better to bad mark it and not use that board on a panel. Safer in the long run as it may have othe
Electronics Forum | Wed Nov 23 07:45:39 EST 2016 | bukas
hello, I have a GSM2 machine with faulty motor driver (i guess), usually when this error occurs i would rest it via button on a panel several times, but this time it doesnt work. what should i check/ measure to locate this problem? there is 7 blink
Electronics Forum | Wed Feb 01 02:11:38 EST 2017 | Rob
Hi Joshua, No, the adhesive lasts 2 or 3 runs. The adhesive is put on manually as is the kapton. It's a big panel for a flex - nearly 300 x 210, so the operator loading the boards onto the pallet and fixing them (then into a buffer) stays well ahe
Electronics Forum | Thu Feb 16 20:55:57 EST 2017 | youngbuck
Was wondering if anybody has experience a zone that will not get up to temperature. I changed the Solid state relay, made sure the thermocouple is working. The only thing I can think of is the bottom heater panel has a corroded/broken wire which is a
Electronics Forum | Mon Apr 03 04:04:06 EDT 2017 | soldertraining
Lasers can be used to depanel individual PCBs from panels. In addition, laser depaneling is often used when very tight tolerances are required for PCBs such as when there is very little room in an enclosure that the board is fitting in to. But the ch