Electronics Forum | Wed Jun 06 06:16:49 EDT 2018 | jacson_vu
Thank for your sharing. I am also trying find out the best parameter for our product.
Electronics Forum | Fri Jul 27 06:52:49 EDT 2018 | cyber_wolf
CP643 does place 0201's. Like I said everything has to be perfect or expect mediocre results at best. When working with smaller parts Fuji CP machines are very picky about table level, part height, and mechanical pick and place parameters.
Electronics Forum | Thu Aug 16 09:10:45 EDT 2018 | sarason
I have a Juki KE750 Instruction Manual if that is of any use sarason
Electronics Forum | Fri Aug 17 10:44:19 EDT 2018 | muzzy
Hello charliem. Thank you so much! Yes, it looks like the information I need. I will try it and report back in a few days. Thank you once again! Regards, M.
Electronics Forum | Tue Feb 19 08:41:02 EST 2019 | prasanth
dear experts, i want your suggestion for getting a profile in Heller 1707 mk iii series re-flow machine ,its 7 zone machine recently we had a solder ability issues , so pls guide me ,how to set rts profile parameters
Electronics Forum | Mon May 27 04:40:21 EDT 2019 | SMTA-Rogers
Dear Steve, We already to do some DOE of reflow profile, but the optimized parameters are not help for the reduction of voids.
Electronics Forum | Wed May 08 09:17:51 EDT 2019 | bobpan
push the 2 left buttons on the membrane panel after releasing the e-stop....this should get you into diagnostics....you then need to reset the system parameters. It may home then. good luck, Bob
Electronics Forum | Fri Oct 18 16:21:27 EDT 2019 | tey422
Since you have a 2nd machine, and another A12 tool, that would be a lot easier to troubleshoot by using the swap part method. Also, try to compare the A12 parameter from the 2nd machine to the "trouble" too.
Electronics Forum | Mon Oct 21 11:05:57 EDT 2019 | tey422
With the given update you provided, that would rule out the nozzle tool issue. If the parameter looks fine, then the issue would be somewhere around the nozzle tool bank. Need to check open and close release. If the nozzle seats flush "not tilted" w
Electronics Forum | Sat Nov 09 20:11:43 EST 2019 | richardcargill
I suspect configuration too. From memory, only certain heads are assignable as 'Fine'. Changing this parameter in the component data to Standard or QFP will most likely cure this as any head will accept those two options