Electronics Forum | Thu Jun 14 14:45:45 EDT 2007 | shrek
Well, whether your parents like it or not, I am an ogre! And guess what, princess Mika? That's not about to change. Princess Mika, all joking aside, the parts placed by my CP6 are billboarded, skewed, and mismounted in the lower left corner of th
Electronics Forum | Thu Jun 14 04:08:33 EDT 2007 | d0min0
we had same problems with heavy loaded boards (40 x 10 leg transformer each side) we placed 2 glue dots (Fuji GL)under trafo and played with profile bottom side (thermateh lcv4 - 6 zones, SnPb process) that did the trick
Electronics Forum | Thu Jun 14 11:26:30 EDT 2007 | mumtaz
It may be your screen printer my friend. You are using a MPM aren't you? I knew it. Try a DEK to rid yourself of these pesky problems.
Electronics Forum | Sat Jun 16 08:40:23 EDT 2007 | davef
Search the fine SMTnet Archives, for instance: http://www.smtnet.com/forums/Index.cfm?CFApp=1&Message_ID=43869
Electronics Forum | Wed Jun 20 11:18:50 EDT 2007 | dboudreau
Hello, I have a question for electronic manufacturers. I would like to know in which cases a solderability test for component leads should be done? Should it be done for all kind of parts or only for those bought from brokers? Also, how often th
Electronics Forum | Mon Jun 25 13:21:15 EDT 2007 | Process Guy
I'm looking for an adjustable, bench top, gravity feed rack that will allow manual assemblers to pull parts to be placed by hand. I know I've seen these out there, but I can't find any information on them on line. Any help at all would be greatly app
Electronics Forum | Thu Jul 05 14:15:28 EDT 2007 | 18424
I ran into the same thing several months ago, I increased my reflow zone temp 10 degrees and this corrected the problem. For some reason it has somthing to do with the plating on the component. I don't know what part you are running but Some of the M
Electronics Forum | Mon Jul 16 10:28:08 EDT 2007 | wana
Thanks guys for the suggestions. But, what I am looking for is data, papers, articles to support this process of using lead free parts in leaded process. Again thanks for any help that you can provide.
Electronics Forum | Fri Jul 20 16:39:18 EDT 2007 | john_smith
Jacky, we have had a similar problem. We needed to go to a smaller nozzle and also check your vacuume system and air kiss.Could be after placement when the machine blows air to insure the part is off the nozzle that it is effecting the solder brick.
Electronics Forum | Tue Jul 17 10:55:13 EDT 2007 | rons
I'm looking for placment cost on machine placed SMT parts. Circuit is 2"x2" on a 6up pallet array. Also has 3 hand placed thru hole caps.