Electronics Forum | Fri Feb 01 16:14:55 EST 2008 | bghusker
We bake components in reels quite often using a low temp oven. If you look under JDEC standards they provide temps and baking times based off of the thickness of the part. The only problem with the low temp is that you could be looking at baking ti
Electronics Forum | Mon Feb 04 16:29:39 EST 2008 | tonyamenson
I have been trying to eliminate the troublesome tubed parts in our SMT process but because we are a high mix/low-medium volume we still have to deal with it sometimes. However, the ones I can fix I'm working on. The next step in my war against tubes
Electronics Forum | Thu Feb 14 22:19:05 EST 2008 | ashley
hello Keith, the problem may be related to a faulty / dirty linear scale. kindly check on the yellow strip along the X axis. clean & clear the glass linear scale of debris & grease. for Fuji support & spare parts, please write to :- apexservice@
Electronics Forum | Thu Feb 14 07:33:24 EST 2008 | cyber_wolf
Does anyone have any experience with this component ? We seem to have some warping issues through reflow. We have tried everything profile wise....pre bake parts etc.
Electronics Forum | Tue Feb 19 13:25:29 EST 2008 | vikkaraja
What other mehtods are used to make a FUJI programs using FLEXA Software? Simplest way I know is to get a text file with the followings:Part#;X-axis; Y-axis; and Referance Location. Thank You.
Electronics Forum | Fri Feb 22 10:46:04 EST 2008 | mulder0990
Yes, we have. We do have one machine that can place the 0201 parts. I have bought some 0.4mm tape leaf covers and replaced the 0.7mm covers on some CP6 0802 feeders. I calibrate the feeders as tight as I can and make sure the feeders that we use a
Electronics Forum | Mon Feb 25 10:04:08 EST 2008 | scotceltic
There are various software programs out there to aid in the creation of visual aids for manual assy. and other steps in the process. We currently use Circuitcam (Aegis). It helps us create color coded (by part number) visual aids for the whole proc
Electronics Forum | Tue Mar 04 17:06:31 EST 2008 | realchunks
Depends on your board? What finish? Solder mask between all pads? What pitch is the part? Will it machine placed? Don't forget proper profiling as well. 1:1 with machine placement should yield no issues.
Electronics Forum | Thu Mar 06 14:44:22 EST 2008 | soudomphong
Would you happen to know where I can get the glass shield part at the bottom? At plccenter cost about $458 dollars and one guy from different source quote me with $1500 dollars. Is this sound right to you?
Electronics Forum | Mon Apr 14 07:31:46 EDT 2008 | leemeyer
Try PPM inc. http://www.goppm.com/ They sell parts & service for Quads and are very helpful with questions.
