Electronics Forum | Mon Sep 06 09:03:45 EDT 2010 | aj
Hi all, Looking for some advice on how to run this component through the SMT process or is it always hand soldered? Part number is HSEC8-120-01-S-D-EM2 We are currently handsoldering. aj...
Electronics Forum | Tue Sep 07 11:04:44 EDT 2010 | mikesewell
Looks like a hand solder process - getting paste down but not smearing it too bad while sliding the connector on is probably not worth the trouble. Teka makes solder bearing connectors which would allow you to install last and simply reflow with the
Electronics Forum | Tue Sep 14 02:12:22 EDT 2010 | genesan
Hi Sir, Thanks for reply and base on our system the same part are using for 2 model only and the problem occur on both assembly.By the way as feedback it happen on random pin of this BGA only.
Electronics Forum | Mon Sep 27 15:57:21 EDT 2010 | mikesewell
I've owned two PDR Lightmaster IR rework stations (bought at 2 diff. companies) and have been extremely happy with them. Closed loop,separate control of top and bottom heater via non contact thermocouples. Control the process, not the product - set
Electronics Forum | Tue Oct 05 03:24:08 EDT 2010 | mskler
This breaks the soldering not the body of the part. It breaks 90 degree from the length of teh componet.Is there any diffrence if I will use the solder paste of the type 4 for the 0603 componet.
Electronics Forum | Wed Sep 29 17:42:08 EDT 2010 | asksmt
TH Parts are hand loaded - some are wave soldered and some hand soldered. smt 1206 on top side can be reflowed as you suggested but it's addition of one more step of reflow cycle in process for production. and i think that's why they are reluctant
Electronics Forum | Mon Oct 04 09:27:43 EDT 2010 | floydf
We have found that the lenses on the Rebels have are gooey and sticky. We put a little bit of WD40 on the shutter part that contacts the lens. Just a little bit. Basicly, put a drop on and try to wipe it all off with a paper towel is enough.
Electronics Forum | Thu Sep 30 10:56:03 EDT 2010 | jdengler
Does anyone have a Fuji CP-IV-3 Feeder parts list manual? If you have it in electronic format that would be best. If you have a hard copy that you want to sell I would be interested also. Thanks, Jerry
Electronics Forum | Fri Oct 01 14:10:40 EDT 2010 | thanh
KINGBRIGHT LED #AAA3528SURKCGKC CAN BE WASH OR NOT??? any one running this part with Water flux and wash it?? we used to run with No Clean, but i want to change the process with water. thanks
Electronics Forum | Fri Oct 08 04:08:37 EDT 2010 | walkbury
Thanks for the reponse.... really appreciated. Just checked pricing with Siemens UK.... Get this.... they want £405 each!!! I'm in the wrong business!!! Anyone know of an alternate source for these parts? Best regards Gary