Electronics Forum | Fri Jun 18 11:31:17 EDT 2004 | gregp
I think it depends on the thickness of the PORON sheet. For .3mm balls you could probably get away with a pretty thin sheet (maybe 1/16"). I don't know how thin it comes offhand. For the part you are describing I woulf try maybe a 3.5mm OD and a 1
Electronics Forum | Fri Nov 01 07:58:48 EST 2002 | stefwitt
Thank you, Cal. Indeed I can offer quality support and service on Siemens machines. For the current low prices of used machines, you may want to consider to buy more machines and compensate for down time. As a registered customer you pay $ 40,000 for
Electronics Forum | Tue Nov 05 17:00:40 EST 2002 | MikeF
Does anyone know of a good basic conformal coat training class for operators? Or can anyone recommend a company that offers a conformal coat training class, in the US? We want to add more capability to our operations, and have stumbled a bit in our
Electronics Forum | Mon Nov 11 09:24:07 EST 2002 | russ
I agree with Dave, Identifying chip components is not worth the time or effort. I believe that you can only tell what the value is and not the voltage,temp rating tolerance, etc...anyway. You will need to then put them back into tape to make them u
Electronics Forum | Tue Nov 19 10:25:45 EST 2002 | mcmilse
I have a question abut flux and solder preforms. We build some assemblies that have deep pockets in which we use solder preforms and add flux before placing parts and then onto reflow. I was wondering if anyone knows anything about how much flux sh
Electronics Forum | Wed Nov 20 07:50:00 EST 2002 | aerineng
Hi, I'm an SMT refugee working in component manufacture - hey, times are hard! I've been asked by a customer to test some of my parts at high temperature on the wave - up to 360 deg Celsius. I've checked my wave and it's only capable of getting up
Electronics Forum | Mon Dec 02 15:56:40 EST 2002 | russ
For CYA reasons you made the right choice (I agree with Mark). But, for whatever it is worth I have used Loctite 383 up to 4 years past it's shelf life It worked fine for my application (wire tacking, FR4 bonding etc...). Have you ever seen a shelf
Electronics Forum | Mon Dec 02 16:19:11 EST 2002 | slthomas
Unfortunately it's nc or we'd be worrying about this on the fly. Non-contact is defintely and issue....this is an 18"x9" board with 1500 bottom side SMT parts that are scattered among the through-hole and vice-versa. We're currently using 7 hold-
Electronics Forum | Wed Dec 11 20:40:25 EST 2002 | davef
Se�or Tech Consider the following in evaluating your adhesive: * Determine the ability to dispense/print epoxy dots over the full range of application diameters/volumes. * Assess the ability to dispense/print epoxy without undesirable characteristic
Electronics Forum | Thu Dec 05 17:40:24 EST 2002 | davef
While unfamiliar with some of the terms you use, could this be what you seek? http://www.pcbstandards.com/downloads/Metric%20Environment/General%20Documentation/PCB%20Design/PCB%20Design%20Routing/Metric%20BGA%20Routing.pdf Stepping backwards just