Electronics Forum | Thu Apr 07 19:17:43 EDT 2022 | cbart
Good afternoon The ISI I was mentioning is interconnections solutions which is a division of Molex. a few years back we ran into a component end of life situation but had thousands of very high dollar bare boards in stock. the package was a BGA and w
Electronics Forum | Thu Apr 07 20:42:19 EDT 2022 | stephendo
The boards were just a little larger than a SOT8. IIRC we had a pizza slicer type depanelizer and it wasn't too bad. We just did enough to populate the bare PCBs we had. Where I am now a customer has us put a QFP and a few other parts on a SOW28 f
Electronics Forum | Tue Apr 19 21:23:37 EDT 2022 | kumarb
Hi. On our YV88X (Emerald-X), we use the edge clamp + Push-IN clamp to secure the PCB. The push-in metal part pops up fine but unable to move this piece to the LEFT or RIGHT using the dial inside the machine. The latch inside the machine is rotated '
Electronics Forum | Sat May 14 00:10:30 EDT 2022 | cbeneat
Alex, I can tell you from experience it took a great deal of experimenting with settings when we first started running these. Our best course of action if the settings aren't making a difference, is the blow off. I've had it, let's say pretty high as
Electronics Forum | Wed Jun 01 12:06:49 EDT 2022 | proceng1
I am not quite clear what you are asking, but I'll give it a shot. Once the P&P program is put into the machine, the operator will load a bare board and step through the program using the machine camera to verify that part outlines match up to the bo
Electronics Forum | Thu Jun 09 16:44:20 EDT 2022 | SMTA-68235204
We currently are using the HIPPO system. It is a nice program. It's cloud based so nothing is stored on sight. This was helpful when my computer crashed. You can add an immense amount of information into the system. If you can think it you can enter
Electronics Forum | Tue Jul 05 07:02:26 EDT 2022 | richardcargill
Possibly, yeah. Or the wrong sized nozzle ( or chipped or blocked ) We have problems occasionally with larger components and vacuum levels. If the component has a makers 'circular void' on the pick up surface then the actual pick coordinates have to
Electronics Forum | Tue Jul 05 07:16:35 EDT 2022 | madisreivik
The problem is that.. 1) it always drops at the same location and the vacuum led shows that machine indeed turns the vacuum off ! 2) the same nozzle picks up much heavier components from other feeders without problems 3) the MTU component - i turn
Electronics Forum | Mon Aug 01 10:31:34 EDT 2022 | spoiltforchoice
I'm not familiar with the machine, but isn't a KE760L an old slow "single head, single gantry" two spindle machine? Any speedup from simultaneous picking would not necessarily be that much of an improvement. Setup as you described is the way I would
Electronics Forum | Tue Aug 16 14:03:00 EDT 2022 | proceng1
We currently use Aegis CircuitCam for our Production work instructions, and machine programs. I am looking for an alternative, as CC is no longer supported. We receive Gerbers (sometimes CAD files) and BOM from our customers. That is all that I can