Electronics Forum | Tue May 22 18:13:44 EDT 2007 | Frank
No, we haven't compared bills because we rarely let it cool completely down over night. I would think that the cost needed maintaining 200C over night versus 310C over night would be about the same, but a little less. But going from 25C up to 3
Electronics Forum | Mon Nov 05 01:26:37 EST 2007 | jmelson
WOW! What a horror story. Well I got a Philips CSM84, having never programmed a P&P machine before, or actually ever seeing one run. I got some manuals with it that were for a different model, but they were pretty close. I had some trouble gettin
Electronics Forum | Tue Nov 20 09:50:07 EST 2007 | rgduval
Only on the bottom side? Run that side first . We usually determine our run process based on the heaviest components, and propensity for falling off during the second reflow process. If there's only the one BGA on that side of the board, we'd tend
Electronics Forum | Tue Nov 20 19:08:15 EST 2007 | Peter
Hello, I would like to ask for opinion on an epoxy application. We apply RTV to bond and secure 2 electronic devices on a PCB. But after noticing the RTV bond breaking off during vibration test, our customer has specs in a 5min 2-part epoxy (made
Electronics Forum | Fri Nov 30 18:27:32 EST 2007 | jmelson
This doesn't help the original poster any, but does the Quad have any sensing of what is going on in the feeder? On the pneumatic or mechanical Philips feeders, if the tape jams in the feeder for some reason, the head just keeps tapping the lever an
Electronics Forum | Fri Dec 14 18:32:39 EST 2007 | kroberson
What machines have you worked with previously? Depending on the programming software used, CP6 can be relativly easy to program. CP6 has been a workhorse in the industry for a long time. One the process is set up, maintain the machines acording t
Electronics Forum | Mon Dec 17 11:55:08 EST 2007 | chef
I recently had the same problems, solder bridges on every thing I made, different customers boards, etc. I wave with no-clean flux. As I sorted out problems (pin holes, blow holes, splatter, etc.) I found a lot of variable factors. I changed flux,
Electronics Forum | Thu Dec 20 23:56:35 EST 2007 | isd_jwendell
I run a prototype/small-run shop, so I'll include some recommendations too: 1) Don't buy a machine for just what you are doing today. Once you get into this field you will find demand to do more. 2) Don't scrimp on the stencil & machine. You will spe
Electronics Forum | Fri Feb 01 17:24:40 EST 2008 | kpm135
I work for a small electronic contract manufacture and we are currently evaluating pick and place equipement hoping to improve the quality of our build and increase our cappacity to boot. We are a high mix/low volume shop and I'd say our average buil
Electronics Forum | Thu Feb 28 08:58:02 EST 2008 | adlsmt
We actually ran production boards on Mydata and Universal Advantis. The Mydata machines software was very command line oriented which I thought was strange but they said they had no intention of upgrading it. The Mydata placement accuracy was superb.