Electronics Forum | Wed May 25 17:48:31 EDT 2011 | rssimmons
The SimmScope is an inspection system that uses an overhead digital microsope on a motorized gantry to inspect the board - much like an AOI - except that it does not automatically make the pass/fail decisions. It is up to the operator to make the de
Electronics Forum | Tue May 31 16:31:02 EDT 2011 | xray
Hi, Besides the 2 machines mentioned which are part comparison machines that require the operator to provide a pass/fail on each ref id, there is a system called the FA Inspector which offers the mode described above and two additional modes: 1. Au
Electronics Forum | Tue Jun 28 20:35:16 EDT 2011 | smellew
Hi you can buy the motors individually direct from Siemens or others suppliers like ourselves SME(Surface Mount Engineering)also many other uk & EU dealers(STM, Adopt, AMS,ISS & CPS, just search you'll find them plus many china suppliers, (Left side
Electronics Forum | Wed Jun 29 14:40:12 EDT 2011 | wrongway
Hello All We are currently running 3 universal smt machines one is an advantis lighting head all 3 machines are 2007 we run 2 shifts 5 days a week I have had very little trouble with them or the feeders. we have 2 universal through hole machines one
Electronics Forum | Wed Feb 22 09:15:06 EST 2012 | sarason
I have done some revision work on the UFOS format. But in my research I found that the format has a bit of variation in it on my old YM6021 the component field has 6 digits and the later YM series it has 8, also does the designator comment crash your
Electronics Forum | Fri Jul 08 09:30:35 EDT 2011 | kahrpr
Check that your pick and place machine is not pushing the part too far in the paste and squeezing the paste off the pad. Your profile could need modifying. In the case of the profile the solder paste can slump off the pads before turning into a liqui
Electronics Forum | Mon Aug 08 16:14:36 EDT 2011 | wmburke
We are building a plasma diagnostic to monitor MHD phenomena in tokamak. As part of the development, we need high-voltage, high-power RF capacitors to tune and match an inductive load. This application is similar to a small induction heater, with t
Electronics Forum | Fri Sep 02 19:31:40 EDT 2011 | jlawson
I agree that if information is processed correctly up front in process down stream QA becomes less expensive ie AOI etc as AOI at end of lines is telling you you have made mistakes in up stream. I better to eliminate mistakes or have process to avoid
Electronics Forum | Mon Aug 29 17:59:24 EDT 2011 | garryc
My first printer was a Speed Print machine back in 2001. We still have it as a backup. I needed a printer quickly so I bought an EKRA from a show. We were very disappointed with that machine. The service was terrible. Parts were impossible to get. I
Electronics Forum | Wed Sep 21 17:53:19 EDT 2011 | action_101
I would like some input on reworking BGA's and the best method. I have reworked BGA's since 1998 using both micro stencils and just flux dipping the parts. I have reworked SN/PB and lead-free (AIM NC258) BGA's for the last 8 yrs. with just flux. I ha