Electronics Forum: part id with feeder (Page 1 of 155)

how can i id smt components that are marked with codes ?

Electronics Forum | Mon Dec 08 11:52:30 EST 1997 | j martin

part of my job function is to id all component requirements for our company. quite often i run into smt components that have mfr codes and not actual component part numbers. does anyone out there know of a way to id these parts.

Re: how can i id smt components that are marked with codes ?

Electronics Forum | Mon Dec 22 02:47:53 EST 1997 | jerdog

what you can do is call the manufacture and get a discription. part of my job function is to id all component requirements for our company. quite often i run into smt components that have mfr codes and not actual component part numbers. does

feeder pitch

Electronics Forum | Tue Feb 15 10:21:19 EST 2005 | gregp

Any tape--any pitch. On our C5 platform every part number (in your database) has a package type assigned to it. The package type contains the information about the pitch and component orientation. When you load the feeder you scan the part number-

feeder maintenance

Electronics Forum | Thu Feb 02 21:14:16 EST 2006 | ____

Fuji America has feeder maintenance manuals for all of the machines. Some of them are on CD-ROM with a step by step procedure. For parts however, you need to be registered (Fuji Japan) so that you can enter the serial number and find the exact part n

feeder pitch

Electronics Forum | Tue Feb 15 04:07:17 EST 2005 | Rob

Yes we have come across 24x20, & we have a couple of feeders set up for it, & no it's not that common a part but you can't be the only Mirae user who has ever tried. What do Mirae have to say?

Problems with Maxim TQFN 38 pin part

Electronics Forum | Wed Mar 14 13:26:48 EDT 2007 | Hussman

Are these blind vias or do they go all the way thru the board?

Problems with Maxim TQFN 38 pin part

Electronics Forum | Thu Mar 22 11:27:13 EDT 2007 | Oswaldo Rey

Good idea, I�ll try this, thanks.

Problems with Maxim TQFN 38 pin part

Electronics Forum | Wed Mar 14 13:52:11 EDT 2007 | Oswaldo Rey

Vias are thru hole, pcb is two sided, bottom copper is 2 sq inches, vias are 0.6mm diameter. thanks,

Problems with Maxim TQFN 38 pin part

Electronics Forum | Fri Mar 16 10:43:31 EDT 2007 | kennyg

A quick experiment idea: Try reflowing a bare board prior to assembly. Perhaps your boards have moisture and outgassing issues.

Problems with Maxim TQFN 38 pin part

Electronics Forum | Tue Mar 13 20:31:39 EDT 2007 | grantp

Hi, We solder a part almost identical to this without problems. Could it be your airflow in your oven is set to high? On our prototypes we didn't place any solder on the middle bad as it was not a connection, and we did not need it thermally, how

  1 2 3 4 5 6 7 8 9 10 Next

part id with feeder searches for Companies, Equipment, Machines, Suppliers & Information