Electronics Forum | Mon Aug 22 15:15:59 EDT 2005 | PWH
Can I please get some opinions on the best way to kit/present parts to the SMT line for high mix/low volume board manufacturing? We currently kit builds using a scrap rate assigned to different package sizes. It is O.K. but could use some refinemen
Electronics Forum | Tue Aug 30 15:29:17 EDT 2005 | pr
I agree with cmiller on almost everything except the fluxer. I have not found that to be the slowest part of the process. On a slightly populated board, preheat will be the biggest cycle time killer. On very highly populated boards, time spent at the
Electronics Forum | Wed Sep 21 08:43:46 EDT 2005 | kmeline
We are having problems with a 1210 cap moving as far as a 1/4 inch from its pads during reflow. We have verified the placement before reflow. They will tombstone some of the time. There are smaller and larger parts around this location and none of th
Electronics Forum | Wed Sep 21 12:14:47 EDT 2005 | Rob
It's quite a big cap so try taping over about 25% of both apertures to restrict the volume of paste printed then see what happens. Also, is anything interfering with the part during placement? or are you 100% sure it's going into the oven ok? if no
Electronics Forum | Thu Sep 22 18:23:14 EDT 2005 | arnie
Hi, I am having a problem with component position on a flex circuit. It is an eight up panel. The flex circuit is mounted on to a piece of fr4 with presure sensitive adhiesive, this is done out of house. The problem is, I will locate the parts on one
Electronics Forum | Tue Oct 11 18:21:36 EDT 2005 | stepheniii
Does it do nozzle changes at a different speed than the programs? It's been a while since I worked on these beasts. I"m wondering if it can handle slow speeds but at full bore it can't handle it. Maybe try one part with everything set to slow speed
Electronics Forum | Sun Oct 23 00:05:50 EDT 2005 | fastek
Nope. Speedline does not charge a registration fee to buy parts. Anyone can buy them. Now service and support......that requires registration. My point was the gentleman will need parts in the future and when he does he will likely be down hard. Bett
Electronics Forum | Tue Nov 01 12:29:35 EST 2005 | russ
I just noticed that you mention 2-5mm off, that is huge! It would seem to me that there is an external force here to move a part that far. Things such as a heavy air stream that for some reason is really hitting this part, something on the PCB unde
Electronics Forum | Wed Nov 09 08:39:59 EST 2005 | smtspecialist
Thanks Avalancher. I had no clue about the fact that Mydata could analyze part for me. Since I'm in montreal it's hard and expensive to get a Mydata guy up here but sending the parts down there would be an great inexpensive solution. I've been over t
Electronics Forum | Fri Nov 18 21:40:41 EST 2005 | mika
We had some experience that some of our old machines went over 10 years. In this case the machines became to be obsolete. The machine manufactories in most cases, is only required to handle spare parts during this period of time. This is what I am be
Buyer, Seller, Broker of Electronic Assembly Equipment
Equipment Dealer / Broker / Auctions
309 West Pickle Alley
Rushford, MN USA
Phone: 507-864-7477